Whirlpool LDE7800W1 Operations Instructions download pdf (Page 9)

(3) LUIIII~LI ttle IICULI~I W;,C of

tho power cupply cnrii

to the

center silver colored terminal of the terminal

block and connect the other wires to the outer

terminals. See illustration labeled “Ungrounded

Neutral.” For connectina olain-end field wire see

illustration labeled “Plain-end Field Wiring.”

CONNECT SEPARATE COPPER GROUND WlRE

FROM EXTERNAL GROUND CONNECTOR

TO APPROVED GROUND

GROUND WRE

0 FUSED DISCONNECT

BOX OR APPROVED

WIRING DEVICE FOR

POWER SUPPLY CORD

UNGROUNDED NEUTRAL

(4) Connect a separate copper qround wire (No. 10

mnimum) to a grounded cold water pipe* by

means of a clamp and then to the frame of the

appliance at the external ground connector. Use

Part No. 685463 ground wire and clamp assembly.

Do not ground to a gas supply pipe. Do not connect

the power supply cord to electric power supply

until appliance is permanently grounded. See

following illustration.

(5) Replace terminal block cover.

“Cold water pope must have metal contlnu~ry 10 electrical ground

anti not be Interrupted by plastic, rubber or other electrically

Insulating connectors iincludIng water meter or pumpl wIthout

addlng a jumper wire at these connections

C. If connecting to a four-wire electrical system (mobile

home):

(1) Remove the terminal block cover by removing the

screw shown in the illustration on page 8.

(2) Remove ground wire (green) from the external

ground connector and fasten under center silver

colored terminal block screw.

(3) Connect the ground wire (green) of the power

supply cord to the external ground connector.

(4) Connect the neutral wire (white) of the power

supply cord to the center silver colored terminal of

the terminal block and connect the other wires to

the outer terminals. See illustration labeled “4-Wire

Ungrounded Neutral.” For connecting plain-end

field wire, see illustration labeled “Plain-end Field

Wiring.”

(5) Replace the terminal block cover by first installing

the tab of the cover into the slot of the dryer rear

panel (see illustration on page 8). Secure the cover

with the mounting screw.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Whirlpool LDE7800W1 Operations Instructions Page 9

Comments to this Manuals