Whirlpool GZ5736XR Series User Manual download pdf (Page 7)

2. Disconnect the light assembly wiring connector.

Make sure not to disconnect any wires.

3. Remove the light panel and set aside.

4. Remove the air chute held in place with one screw.

5. Remove baffle from air chute.

6. Rotate baffle and reinsert it back into the air chute so that the

baffle tabs fit all the way into the slots in the air baffle.This will

close off the air flow through the non-vented slots on top of

the hood.

7. Replace air chute.

8. Connect light assembly wiring connector and replace light

panel.

NOTE: Make sure not to trap wires between the support fin

and light panel.

A. Light panel

A. Air chute

top of hood. Set vent plate and mounting screws aside.

2. Remove tape holding standard filters in place. Remove both

filters. Insert flat blade screwdriver into slots in filters. Push

each filter toward back of hood, lift out and set aside.

3. Remove damper/vent connector from inside the hood. Set

connector, mounting screws and parts bag aside.

4. Remove wiring cover from inside the hood. Set cover and

mounting screw aside.

5. Depending on your installation, remove either top or back

wiring knockout and install a ¹⁄₂" UL- or CSA-listed strain

relief.

For non-vented installations

Go to “Make Electrical Connection” section.

For vented installations

1. Remove the five screws holding the light panel in place and

set them aside.

A. Damper/vent connector

A. Wiring cover

A. Strain relief

A. Baffle

A. Tab slots

B. Tabs

A. Filter slots

B. Flat blade screwdriver

1 2 3 4 5 6 7

No comments

Whirlpool GZ5736XR Series User Manual Page 7