Install properly...
1. Allow y2 inch (1.25 cm) space on each side and
at the top of the refrigerator for ease of
installation.
2. If the refrigerator is to be against a wall, you
might want to leave extra space so the door
can be opened wider.
3. The refrigerator back can be flush against the
wall.
Level refrigerator-freezer...
I
USE SCREWDRIVER
TO ADJUST
FRONT ROLLER
1. Remove base grille (see page 8).
2. To raise front, turn screw in direction shown.
3. To lower front, turn screw in the direction shown.
4. Check with level.
5. Replace base grille (see page 8).
Remove sales labels...
Remove the Consumer Buy Guide label, tape
and any inside labels before using the re
frigerator. To remove any remaining glue:
1. Rub briskly with thumb to make a ball then
remove.
OR
2. Soak area with iiquid hand dishwashing
detergent before removing glue as described
in step 1.
DO NOT USE rubbing aicohol or flammable or
toxic soivents, such as acetone, gasoline, car
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN
STRUCTIONS LABELS INSIDE YOUR REFRIGER
ATOR.
Do not remove the Tech sheet tastened under
the retrigerator at the tront.
Clean it...
Clean your refriger
ator before using it.
See cleaning instruc
tions on page 9.
Plug it in...
3-PRONG GROUNDING
TYPE WALL RECEPTACLE
REFRIGERATOR
POWER CORD
3-PRONG
GROUNDING PLUG
RECOMMENDED GROUNDING METHOD
A115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is
required. It is recommended that a separate cir
cuit serving oniy this appliance be provided.
Do not use an extension cord. Use a recepta-
cie which cannot be turned off with a switch or
puii chain. See individual electrical requirements
and grounding instruction sheet in your literature
package.
Comments to this Manuals