Whirlpool UW8 F1C WB F Instruction for Use download pdf (Page 14)

8.2. FAILURES

In the event of operation alarms, they will also be displayed in the digits LEDs, (e.g. Failure1, Failure 2, etc...) call

After-sales Service and specify the alarm code. The acoustic alarm sounds, the Alarm icon

lights up and the F

letter on the digit display blinks according to failure code described below:

Failure code 

Error 2

F letter blink on/off at 0,5 sec. Blinks ON 2 times

then remain off for 5 seconds. Pattern repeats.

Error 3

F letter blink on/off at 0,5 sec. Blinks ON 3 times

then remain off for 5 seconds. Pattern repeats.

Error 6

F letter blink on/off at 0,5 sec. Blinks ON 6 times

then remain off for 5 seconds. Pattern repeats.





Switch the appliance on again to see if the problem has been solved. If it has not, disconnect the appliance from

the power supply and wait for about an hour before switching on again.

If, after performing the checks described in the Troubleshooting Guide and switching the appliance on again, your

appliance still does not work properly, contact the After-sales Service, explain the problem.

Specify:

• the model and appliance serial number (stated on the rating plate),

• the nature of the problem,

• the Service number (the number after the word SERVICE on the data plate on the inside of the appliance),

• your full address,

• your telephone number and area code.

Note:

The direction of door opening can be changed. If this operation is performed by After-sales Service it is not

covered by the warranty.

1 ... 13 14 15 16 17 18 19 20

No comments

Whirlpool UW8 F1C WB F Instruction for Use Page 14