Whirlpool ART 291/G-T1 Instruction for Use download pdf (Page 9)

N C

M Y

AFTER SALES SERVICE

Before contacting our after sales service:

1. Try to remedy the problem (see

“Troubleshooting guide”).

2. Restart the appliance to see if the fault

repeats.

If the malfunction persists, switch off the

appliance and switch on again after an hour.

3. If the malfunction still persists, contact our

Customer Service, specifying:

x the nature of the problem

x the appliance model

x The Service number (the number after the

word SERVICE on the rating plate located on

the side of the fruit and vegetable drawer).

x Your full address

x Your telephone number complete with area

code.

Note: Door opening direction changes

effected by our Customer Service are not

covered by the terms of guarantee.

INSTALLATION

x Do not install the appliance in the vicinity of a

heat source.

x Install the appliance in a dry and well

ventilated room.

x Make sure there is sufficient clearance above

and below the refrigerator to ensure free air

circulation.

x Clean the appliance interior (see “How to clean

the refrigerator compartment”).

x Mount the accessories.

ELECTRICAL CONNECTION

x Electrical connections must be made in

accordance with local regulations.

x Voltage and power consumption information is

shown on the rating plate on the side of the

fruit and vegetable drawer.

x The appliance must be earthed as

prescribed by law. The manufacturer

declines all liability for injury to persons

and animals or damage to property

resulting from failure to comply with this

requirement.

x If the appliance plug and wall socket are

incompatible, the socket must be replaced by a

qualified electrician.

x Do not use extension leads or multiple

adapters etc.

FREE-STANDING APPLIANCES

(only)

x Mount the spacers (if provided) on the back

of the condenser behind the appliance (see

figure).

x For best performance, leave a clearance of at

least 5 cm above the appliance and enough

spacebetweentheapplianceandthe

adjacent furniture to allow air to circulate.

x Make sure the appliance is perfectly level

andifnecessary,adjustthefrontfeet.

ELECTRICAL DISCONNECTION

x Disconnect the appliance from the mains by

removing the plug or disconnecting the two-

pole circuit breaker upstream of the socket.

9

9

1 2 3 4 5 6 7 8 9

Comments to this Manuals

No comments