Whirlpool DPA25 Instruction for Use download pdf

BEFORE USING THE APPLIANCE

• This appliance is intended to be used in

household and similar applications such as

- staff kitchen areas in shops, offices and other

working environments;

- farm houses and by clients in hotels, motels and

other residential type environments;

- bed and breakfast type environments.

To ensure best use of your appliance, carefully

read the operating instructions which contain

a description of the product and useful advice.

Keep these instructions for future reference.

1. After unpacking the appliance, make sure it is

not damaged and that the door closes properly.

Any damage must be reported to the dealer

within 24 hours of delivery of the appliance.

2. Wait at least two hours before switching the

appliance on, to ensure that the refrigerant

circuit is fully efficient.

3. Installation and the electrical connection must be

carried out by a qualified technician according to

the manufacturer’s instructions and in

compliance with the local safety regulations.

4. Clean the inside of the appliance before using it.

1. Packing

The packing material is 100% recyclable and bears

the recycling symbol . For disposal, comply with

the local regulations. Keep the packing materials

(plastic bags, polystyrene parts, etc.) out of the

reach of children, as they are a potential source of

danger.

2. Scrapping/Disposal

The appliance is manufactured using recyclable

material.

This appliance is marked in compliance with

European Directive 2002/96/EC on Waste

Electrical and Electronic Equipment (WEEE). By

ensuring the correct disposal of this appliance, you

can help prevent potentially negative consequences

for the environment and the health of persons.

The symbol on the appliance, or on the

accompanying documents, indicates that this

appliance should not be treated as domestic waste

but must be taken to a special collection centre for

the recycling of electrical and electronic equipment.

When scrapping the appliance, make it unusable by

cutting off the power cable and removing the doors

and shelves so that children cannot easily climb

inside and become trapped.

Scrap the appliance in compliance with local

regulations on waste disposal, taking it to a special

collection centre; do not leave the appliance

unattended even for a few days, since it is a

potential source of danger for children.

For further information on the treatment, recovery

and recycling of this product, contact your

competent local office, the household waste

collection service or the shop where you

purchased the appliance.

Information:

This appliance does not contain CFCs. The

refrigerant circuit contains R134a (HFC) or R600a

(HC) (see the rating plate inside the appliance).

Appliances with Isobutane (R600a): isobutane is a

natural gas without environmental impact, but is

flammable. Therefore, make sure the refrigerant

circuit pipes are not damaged.

This product may contain Fluorinated Greenhouse

Gases covered by the Kyoto Protocol; the

refrigerant gas is inside a hermetically sealed

system.

Refrigerant gas: R134a has a Global Warming

Potential of (GWP) 1300.

Declaration of conformity

• This appliance has been designed for preserving

food and is manufactured in compliance with

Regulation (CE) No. 1935/2004.

• This appliance has been designed, manufactured

and marketed in compliance with:

- safety objectives of the “Low Voltage”

Directive 2006/95/CE (which replaces

73/23/CEE and subsequent amendments);

- the protection requirements of Directive

“EMC” 2004/108/EC.

Electrical safety of the appliance can only be

guaranteed if it is correctly connected to an

approved earthing system.

SAFEGUARDING THE ENVIRONMENT

1 2 3 4 5 6 ... 12 13

Summary of Contents

Page 1 - SAFEGUARDING THE ENVIRONMENT

16BEFORE USING THE APPLIANCE• This appliance is intended to be used inhousehold and similar applications such as- staff kitchen areas in shops, office

Page 2 - RECOMMENDATIONS

255. Loosen the screw holding the top hinge pin. Rotate the pin 180° and retighten the screw(Fig. 6).6. Reassemble the top hinge on the left hand side

Page 3 - COMPARTMENT

26Model BChanging The Door Swing Direction to Right Hand1.Remove the 2 screws holding the middle hinge. Remove the 2 plugs from the middle left hand h

Page 4 - HOW TO OPERATE THE FREEZER

274. Unscrew the pin located on the right (Fig. 6/Detail-A) and screw it to the left (Fig. 6/Detail-B)5. Replace the top bushing and top bushing cap (

Page 5 - HOW TO DEFROST AND CLEAN THE

28ELECTRICAL CONNECTION1) For Great Britain onlyWarning - this appliance must be earthedFuse replacementIf the mains lead of this appliance is fitted

Page 6 - CARE AND MAINTENANCE

17INSTALLATION• The appliance must be handled and installed bytwo or more persons.• Be careful not to damage the floors (e.g.parquet) when moving the

Page 7 - TROUBLESHOOTING GUIDE

18HOW TO OPERATE THE REFRIGERATOR COMPARTMENTThis appliance is a refrigerator with a star freezer compartment.Defrosting of the refrigerator compart

Page 8 - INSTALLATION

19HOW TO OPERATE THE FREEZER COMPARTMENTThe freezer is a star compartment.This compartment can be used to store frozen foods for the period of time i

Page 9

20HOW TO DEFROST AND CLEAN THE FREEZERHOW TO CLEAN THE REFRIGERATOR COMPARTMENTDefrost the freezer compartment once or twice a year, or when the ice o

Page 10

21CARE AND MAINTENANCE• Periodically clean air vents and the condenser at the rear of the appliance with a vacuum cleaner or a brush.• Clean the outsi

Page 11

22TROUBLESHOOTING GUIDEWhen you hear these noises1. The appliance is not working.• Is there a power failure?• Is the plug properly inserted in the soc

Page 12 - DETAIL-B

23AFTER-SALES SERVICEBefore contacting After-Sales Service:1. See if you can solve the problem yourself with the help of the “Troubleshooting guide”.2

Page 13 - ELECTRICAL CONNECTION

24Model AChanging The Door Swing Direction to Right Hand1.Remove the 2 caps from the top of the freezer door. Remove the 2 screws holding the middle h