Whirlpool GC5SHEXNS01 Specifications download pdf (Page 5)

Routing dimensions for Custom panels more than

1/4” (6 mm) thick

Route the entire length or selected areas of handle side of panels

2¹⁄₂” (63.5 mm).

Location Requirements

NOTES:

■ The cabinet depth refrigerator can be installed into a

recessed opening, at the end of cabinets or as a freestanding

refrigerator.

■ If you are installing the refrigerator to fit flush with the front of

the base cabinets, all shoe molding and baseboards must be

removed from the rear of the refrigerator opening.

■ A trim kit is available for those installations in which the

refrigerator will not fit flush. See the “Assistance or Service”

section in the Use and Care Guide for ordering information.

■ For full-overlay cabinet doors, the height of the opening must

be 72¹⁄₈ in. (183.2 cm).

■ Location should permit doors to open fully. See the “Door

Swing Dimensions” section.

■ Do not install the refrigerator near an oven, radiator, or other

heat source, nor in a location where the temperature will fall

below 55°F (13°C).

■ Floor must support refrigerator weight (more than 600 lbs.

[272 kg], door panels and contents).

Electrical Requirements

Before you move your refrigerator into its final location, it is

important to make sure you have the proper electrical

connection:

Recommended grounding method

A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused, grounded

electrical supply is required. It is recommended that a separate

circuit serving only your refrigerator be provided. Use an outlet

that cannot be turned off by a switch. Do not use an

extension cord.

IMPORTANT: If this product is connected to a

GFCI (Ground Fault Circuit Interrupter) protected outlet, nuisance

tripping of the power supply may occur, resulting in loss of

cooling. Food quality and flavor may be affected. If nuisance

tripping has occurred, and if the condition of the food appears

poor, dispose of it.

NOTE: Before performing any type of installation, cleaning, or

removing a light bulb, turn the control (Thermostat, Refrigerator

or Freezer Control depending on the model) to OFF and then

disconnect the refrigerator from the electrical source. When you

are finished, reconnect the refrigerator to the electrical source

and reset the control (Thermostat, Refrigerator or Freezer Control

depending on the model) to the desired setting.

2¹⁄₂"

(63.5 mm)

min.

¹⁄₄" (6 mm) max.

handle

panel

1¹⁄₂" (38.1 mm)

min.

Handle side detail

¹⁄₄"

(6 mm) max.

¹⁄₂"

(12.7 mm)

min.

panel

Top, bottom and side trim detail

WARNING

Explosion Hazard

Keep flammable materials and vapors, such as

gasoline, away from refrigerator.

Failure to do so can result in death, explosion,

or fire.

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Failure to follow these instructions can result in

death, fire, or electrical shock.

Do not use an extension cord.

Do not use an adapter.

Do not remove ground prong.

1 2 3 4 5 6 7 8 9 10 ... 15 16

Comments to this Manuals

No comments

Whirlpool GC5SHEXNS01 Specifications Page 5

Comments to this Manuals

Related products and manuals for Fridges Whirlpool GC5SHEXNS01