Whirlpool KDDC24FVS Specifications download pdf (Page 5)

TOOLSNEEDED:

Gather the required tools and parts before starting installation.

Read and follow the instructions provided with any tools listed

here.

• Cordless drill

• 1/8"Drill bit

INSTALLATION REQUIREMENTS

NOTE: When leveling legs are fully extended to 1" (25 mm)

below the refrigerator drawers, add 3/4"(19.05 mm) to the

height dimensions. See "Product Dimensions."

• If the floor of the opening is not level with the kitchen floor,

shim the opening to make it level with the kitchen floor.

• Tape measure

• Level

• Phillips screwdriver

Additional Tools Needed for Style 2: Overlay (only):

• Scissors • Scribe

• Pencil

PARTS NEEDED Style 2: Overlay (only):

• Custom Overlay Drawer Panels --

See "Style 2: Custom Overlay Drawer Panels."

• Hardware

• Screws (16)

PARTS SUPPLIED:

• Hooks (8)

• Overlay plates (4)

Explosion Hazard

Keep flammable materials and vapors, such as

gasoline, away from refrigerator drawer(s).

Failure to do so can result in death, explosion, or fire.

NOTES:

• For the refrigerator drawers to be flush with the front of the

base cabinets remove any baseboards or moldings from the

rear of the opening. See "Product Dimensions" and later in

this section "Opening Dimensions (both styles)."

• It is recommended that you do not install the refrigerator

drawers near an oven, radiator, or other heat source.

• Do not install in a location where the temperature will fall

below 55°F (13°C).

Opening Dimensions (both styles)

• Height dimensions are shown with the leveling legs extended

to the minimum height of 1/4"(6.35 mm) below the refrigerator

drawers.

//. (

24" (60.96 cm) min.

.......................A 34%" (87.3 cm) min.

35" (88.9 cm) max.

0.96 cm) IX__

rnin,

Critical Dimensions:

A. 14_" (37.5 cm) utility opening

B. 24" (60.96 cm) minimum opening width

_,_ _ _, ......

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,

fire, or electrical shock.

Before you move your refrigerator drawers into the final location,

it is important to make sure you have the proper electrical

connection.

Recommended grounding method

A 115 Volt, 60 Hz., AC only, 15- or 20-amp fused, grounded

electrical supply is required. It is recommended that a separate

circuit serving only your refrigerator drawers be provided. Use an

outlet that cannot be turned off by a switch. Do not use an

extension cord.

1-®TORX is a registered trademark of Textron Innovations Inc.

1 2 3 4 5 6 7 8 9 10 ... 51 52

Comments to this Manuals

No comments

Whirlpool KDDC24FVS Specifications Page 5

Comments to this Manuals

Related products and manuals for Fridges Whirlpool KDDC24FVS