Whirlpool Roper RT16DKXDN03 User Manual download pdf (Page 19)

Connecting to refrigerator

1. Disconnect the tube clamp on the back

of the product and insert copper tubing

through the clamp as shown at the right.

Attach the copper tube to the valve inlet

using a compression nut and sleeve as

shown. Tighten the compression nut. Do

not overtighten. Reattach the tube clamp

and tube to the back of the cabinet. Move

to step 2.

2. Turn shut-off valve ON. CHECK FOR

LEAKS. TIGHTEN ANY CONNECTIONS

(INCLUDING CONNECTIONS AT THE

VALVE) OR NUTS THAT LEAK.

3. The ice maker is equipped with a built-in

water strainer. If local water conditions

require periodic cleaning or

a

well is your

source of water supply, a second water

strainer should be installed in the X-inch

water line. Obtain a water strainer from

your nearest appliance dealer. Install at

either tube connection.

4. Reconnect electrical supply to refrigerator.

1

Use only %-inch

copper tubing from

.I

cold water line

Wate

valve

nut and sleeve

Removing the base grille

Burn Hazard

Do not touch refrigeration tubes near

defrost pan.

Doing so can result in burns.

To remove the base grille:

1. Open the refrigerator door.

2. Grasp the grille with both hands.

3. Push down on the top edge of the grille

to release the top clips.

4. Roll the grille toward you to release the

top clips.

5. Pull grille away from the refrigerator.

NOTE: Do not remove the Tech Sheet

fastened behind the grille.

Condenser

Defrost

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 31 32

Comments to this Manuals

No comments