Whirlpool WRID45T User Manual download pdf (Page 15)

Door Open Sensing Alarm

Door open sensing alarm activates or gives beep if the door is kept open for more than 2 min.

During the Door opening beep alarm if the door is closed then the alarm gets deactivated.

Alarm Codes, Priority, Retention and Trigger

Alarm code for Deluxe models: -

• In event of any Fault accurring for RC/FC or Pot sensors then immediately after 2 min’s of the

fault occurrence a Buzzer Beep for 1 Sec will be activated indicating the Sensor fault condition in

Dlx models only.

• To understand where there is any Sensor or Pot failure indication in the Dlx model, Service Person

should Switch On the Product & wait for the any buzzer Beep if any after 5 sec of Product switch

ON. This will indicate the Error status in the Dlx models.

Check Point:

- Poor contact between terminals/ connectors – CN2 (Temperature Sensors) at Electronic Control

(main board)

- The Sensor/Pot itself that might be open or in short circuit and has to be replaced (see Sensor/Pot

replacement).

Safe mode routine

During Constant fault condition, the Electronic Control will assume a safety routine, as in normal

cycle, trying to keep food conservation, however will work as follows:

• Compressor and Fan Motors will be on for 25 minutes and then will turn off for 20 minutes.

• Interval set between defrosts will be fixed in every 5 hours of the Compressor activity

• Every defrost time is fixed for 20 minutes. No dependency on defrost sensor for Cut Off temp of

15°C

Normal

Compressor

/Product

running

Mode

Sensor

Failed??

(Open/Shor

t Mode)

{RC, FC or

Ambient

Sensor)

Start Safe mode

routine

after 2 min of

error

Event in sensor

Yes

Normal

Compressor

/Product

running

Mode

Whether

sensor/POT

repaired/correc

ted??

Yes

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 25 26

Comments to this Manuals

No comments

Whirlpool WRID45T User Manual Page 15

Comments to this Manuals

Related products and manuals for Fridges Whirlpool WRID45T