Whirlpool WSR57R18DM Use and Care Manual download pdf (Page 5)

Refrigerator Leveling and Door Closing

Your refrigerator has two front adjustable legs, one on each side. The

back of the refrigerator rests on two fixed rollers. The base grille covers

the adjustable brake feet and roller assemblies located at the bottom of

the refrigerator below the refrigerator door. Before making any

adjustments, remove the base grille and move the refrigerator to its

final location.

Tools Needed: ¹⁄₄" hex driver, Phillips screwdriver

1. Remove the base grille screws. Grasp the grille firmly and pull it

toward you. Open the refrigerator door to access the brake feet.

NOTE: To allow the refrigerator to roll more easily, raise the brake

feet by turning them counterclockwise. The front rollers will be

touching the floor.

2. Move the refrigerator to its final location.

3. Lower the brake feet, by turning them clockwise, until the rollers

are off the floor and both brake feet are snug against the floor.

This keeps the refrigerator from rolling forward when opening the

refrigerator door.

IMPORTANT: If you need to make further adjustments involving the

brake feet, you must turn both brake feet the same amount to keep

the refrigerator level.

4. Make sure the door closes easily. If you are satisfied with the door

opening and closing, skip the next section. If, however, the door

does not close easily or the door pops open, adjust the tilt.

A. Grommet

B. Handle

C. Setscrews

Handle

Door Removal and Replacement

Top Hinge

A. Top Hinge Cover

Hex-Head Hinge Screws

C. Top Hinge

Bottom Hinge

A. Hinge Pin

Hex-Head Hinge Screws

1 2 3 4 5 6 7 8 9 10 ... 23 24

No comments

Whirlpool WSR57R18DM Use and Care Manual Page 5