6
REMOVE THE HOB.
- To remove the hob, use a screwdriver (not provided) to prise o the xing clips on the underside of the appliance.
ELECTRICAL CONNECTION
- Disconnect the appliance from the power supply.
- Installation must be carried out by qualied personnel who know the current safety and installation regulations.
- The manufacturer declines all liability for injury to persons or animals and for damage to property resulting from failure to observe the regulations
provided in this chapter.
- The power cable must be long enough to allow the hob to be removed from the worktop.
- Make sure the voltage specied on the dataplate located on the bottom of the appliance is the same as that of the home.
Connection to the terminal block
For the electrical connection, use an H05RR-F cable as specied in the table below.
Conductors Amount x size
220-240V ~ +
230-240V ~ +
380-425V 2N~ +
220-240V 3~ +
380-415V 3N~ +
3 x 4 mm
3 x 4 mm (Australia only)
4 x 1,5 mm
5 x 1,5 mm
4 x 1,5 mm
The appliance must be connected to the electricity supply by means of an omnipolar switch with minimum contact gap of 3mm.
IMPORTANT: the yellow/green earth wire must be connected to the terminal with the symbol and must be longer than the other wires.
• Check the connection diagram label under the hob and place/remove bridges according the connection type;
• Remove approx. 70 mm of the cable sheath from the power supply cable (B);
• Strip approx. 10 mm of sheath from the wires. Then insert the power supply cable into the cable clamp and connect the wires to the terminal block as
indicated in the connection diagram placed close to the terminal block itself;
• Secure the power supply cable (B) by means of the cable clamp;
• Close the terminal board with the cover (A) securing it with the screw provided;
• After the electrical connection, t the hob inside the cut-out.
CONTROL PANEL DESCRIPTION
Control panel
Timer controls
and display
Zone controls and display
On/Off
MeltingBoiling
Control panel lock
Dual/Triple
zone
Comments to this Manuals