Whirlpool GOR 6416/NB Instruction for Use Page 4

  • Download
  • Add to my manuals
  • Print
  • Page
    / 4
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 3
PRATICAL ADVICE FOR USING THE BURNERS
IMPORTANT: WHEN THE HOB IS IN USE, THE ENTIRE HOB AREA MAY BECOME HOT.
To ignite one of the burners, turn the relative knob anti-clockwise to the maximum flame setting.
Press the knob against the control panel to ignite the burner.
After the burner has ignited, keep the knob pressed for about 5-10 seconds to allow proper device operation.
This burner safety device shuts off the gas supply to the burner if the flame goes out accidentally (because of sudden
draught, an interruption in the gas delivery, boiling over of liquids, etc.).
The knob must not be pressed for more than 15 sec. If, after that time has elapsed, the burner does not remain lit,
wait at least one minute before trying to light it again.
NOTE: should particular local conditions of the delivered gas make the ignition of burner difficult, it is advisable to repeat
the operation with the knob turned to small flame setting.
The burner might go out when the knob is released. This means that the safety device has not warmed up enough. In this
case, repeat the operations described above.
DIMENSIONS AND DISTANCES TO BE MANTAINED (mm)
WOK ADAPTER (not included,this accessory can be purchased separately from the After-sales Service)
This hob has burners of different diameters. For better burner performance,
please stick to the following rules:
- Use pots and pans with bottoms the same width as that of the burners or
slightly larger (see table on the right).
- Only use flat-bottomed pots and pans.
- Use the correct amount of water for cooking foods and keep the pot covered.
- Make sure pots on the grates do not protrude beyond the edge of the hob
- In the case of pans with convex bottoms (WOK), use the support grille
provided, which should be positioned only on the 4 ring burner.
IMPORTANT: improper use of the grids can result in damage to the hob: do
not position the grids upside down or slide them across the hob.
Do not use:
- Cast iron griddles, ollar stones, terracotta pots and pans.
- Heat diffusers such as metal mesh, or any other types.
- Two burners simultaneously for one receptacle (e.g. fish kettle).
Liquids spilled on hot hob area can cause glass damage.
Burner Pot Ø
Rapid From 24 to 26 cm
Semi-rapid From 16 to 22 cm
Auxiliary From 8 to 14 cm
HOW TO USE THE HOB
WARNING
Do not let the burner flame extend beyond the edge of the pan.
NOTE: if the distance “A” between the wall cabinets is
between 600 mm and 730 mm, the height “B” must be a
minimum of 530 mm.
If the distance “A” between the wall cabinets is greater
than the width of the cooktop, the height “B” must be a
minimum of 400 mm.
In case of installation of a hood above the cooktop, please
refer to the hood instructions for the correct distance
max. 492
510
41
560
590
min. 70
max.R 8
max.R 6,5
min. 480
750 min.
50 min.
A
B
B
100
INJECTORS TABLE CATEGORY II2H3B/P - II2HS3B/P (HU)
Type of gas
used
Type of
burner
Injector
marking
Rated thermal
flow rate
Rated
consumption
Reduced heat
capacity kW
Gas pressure
mbar
kW min. rat. max.
NATURAL GAS
(Methane) G20
Rapid 128B 3.00 286 l/h 0.60
17 20 25Semi-rapid 95 1.65 157 l/h 0.35
Auxiliary 78A 1.00 95 l/h 0.30
LIQUEFIED
PETROLEUM GAS
(Butane) G30
(Propane) G31
Rapid 87 3.00 218 g/h 0.60
25 30 35
Semi-rapid 67 1.65 120 g/h 0.35
Auxiliary 50 1.00 73 g/h 0.30
HU*
NATURAL GAS
(Methane) G20
Rapid 122A 3.00 286 l/h 0.70
20 25 33Semi-rapid 92 1.65 157 l/h 0.40
Auxiliary 74 1.00 95 l/h 0.35
NATURAL GAS
G25.1
Rapid 131 3.00 332 l/h 0.60
18 25 33Semi-rapid 102A 1.65 183 l/h 0.35
Auxiliary 81 1.00 111 l/h 0.30
LIQUEFIED
PETROLEUM GAS
(Butane) G30
(Propane) G31
Rapid 87 3.00 218 g/h 0.60
20 30 35
Semi-rapid 67 1.65 120 g/h 0.35
Auxiliary 50 1.00 73 g/h 0.30
Type of gas used Model
configuration
Rated thermal
flow rate (kW)
Total rated
consumption
Air required (m
3
) for
burning 1 m
3
of gas
G20 20 mbar 1 R - 2 SR - 1 AUX 7.30 695 l/h 9.52
G30/G31 30 mbar 1 R - 2 SR - 1 AUX 7.30 531 g/h 30.94
HU*
G20 25 mbar 1 R - 2 SR - 1 AUX 7.30 695 l/h 9.52
G25.1 25 mbar 1 R - 2 SR - 1 AUX 7.30 809 l/h 8.187
G30/G31 30 mbar 1 R - 2 SR - 1 AUX 7.30 531 g/h 30.95
ELECTRIC SUPPLY: 220-240 V ~ 50/60 Hz
*If the appliance is intended to be in use in Hungary, injectors already assembled (G20 - 20mbar)
must be replaced according to Hungarian market regluation, available in Instruction for User.
Injectors for replacement are available in the kit. Please refer to User Manual information.
Injector replacement must be done by a qualified technician.
Page view 3
1 2 3 4

Comments to this Manuals

No comments