Whirlpool 15080000 User Manual download pdf (Page 16)

Document ID:1 508000

Rev: E Technical Su pport: 8 0

-62

-691

Page 16 of 2

Crystal Clean

™

Pipe-Free

Spa - Operating Instructions

Preparing the Pedicure Spa for Operation:

After the pedicure spa is installed and the plumbing and electrical connections are made, clean and disinfect

the basin before initial use. Rinse the basin by using the attached w ater sprayer. Wipe the basin dry with a

clean tow el.

To Operate the Pedicure Spa, Follow These Easy Steps:

Adding Water to the Pedicure Spa Basin:

1. Close the drain by turning the chrome drain handle counter-clockw ise until it stops.

2. Add w ater to the basin by lifting upw ard on the w ater faucet fill handle. Turn the handle in a counter-

clockw ise direction for cold w ater or clockw ise for warm w ater as indicated by the red (hot) and blue

(cold) markings around the handle ( CAUTION: hot w ater can burn skin). Continue to add w ater until the

top of the f ill line is reached. The fill line is indicated by the w avy (~~~~) line in the basin.

3. Turn the w ater off by pushing the handle dow nward and center.

Operating the Crystal Clean

™

Pipe-Free

System :

The Crystal Clean

™

Pipe-Free

System eliminates pipes and traditional style jets that can harbor harmful

bacteria w hile at the same time delivering a soothing, quality foot massage. This unique system is driven by

an impeller that pulls w ater through the inlet cover and then forces the water outward through key massage

zones in the footplate. The end result is a soothing massage delivered to all areas of the foot: front, back

and bottom.

To start or stop the w hirlpool, depress the On\Off button w ith finger (not fingernail) (NOTE: An i ndica tor

light on the “Jets” button flashes when the footplate is improperly installed, or the basin contains no

wa ter. As a resul t, the whirlpool will not functi on. To fi x, si mpl y check tha t the footpla te i s secur el y

fastened or add water to the basin).

Removing Water from the Pedicure Spa Basin:

First, make certain the w hirlpool jets are turned off by pressing the On/Off switch. The impeller motor w ill quit

running w hen in the “Off” position.

Open the drain by turning the drain handle in a clockw ise direction until it stops, the drain plunger w ill open

and drain pump w ill start to operate. The w ater level w ill low er as w ater is pumped out of the basin. Turn the

pump off by turning the drain handle in a counter-clockw ise direction once the basin is fully drained (NOTE:

the PDP will automatically shut off after 2-1/2 minutes. We recommend turning off the pump

manually if all water has drained before automatic shut-off).

Warning:

It i s e xtremel y importa nt to follow the clea ni ng instr ucti ons l oca ted on the foll owing page. Fail ure to

clean the pedicure spa adequately can result in serious health issues for your clients as well as the

nail techni cia n. Faili ng to cl ea n your pedi cure spa ma y al so cause the pedi cure spa to not work

properl y. Plea se consul t your local a nd sta te codes concerni ng pedi cure chair cl ea ni ng for further

requirements. Failure to follow local and state codes may result in monetary fines.

1 2 ... 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Whirlpool 15080000 User Manual Page 16

Comments to this Manuals

Related products and manuals for Kitchen Whirlpool 15080000