Whirlpool CA15WYR0 User Manual Page 7

  • Download
  • Add to my manuals
  • Print
  • Page
    / 24
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 6
7
2. Insert carriage bolt up through slot on tray-frame side and
support leg.
3. Place one end of tray center over carriage bolt.
4. Then place flat washer, lock washer and hex nut.
NOTE: Do not tighten. The leg must be able to move freely to
adjust angle when installed.
5. Insert second carriage bolt through tray side and attach other
end of support leg.
NOTE: Do not tighten. The leg must be able to move freely to
adjust angle when installed.
6. Install support leg on other side.
Install SMART-MOUNT
®
Tray Assembly in Window
1. From inside, place SMART-MOUNT
®
tray, support legs facing
down, in the window. Match the holes in tray side with the
predrilled holes in windowsill.
2. Using 2 - #10 - 12 x 1¹⁄₂" slot-head wood screws, secure the
tray frame to the window.
NOTE: If the exterior of building can be damaged by support
legs, place a board between the wall and support legs.
3. With tray center pushed away from the windowsill, place a
level on the angled edge on top of the tray side. Be sure level
is against notch on tray side.
4. Adjust SMART-MOUNT
®
tray until bubble indicates the
angled edge on top of the tray side is level.
IMPORTANT: The tray must slope downward slightly toward
the outside to provide proper drainage for the air conditioner.
5. Tighten the hex nut just enough to hold tray center in place.
6. Repeat with other side.
7. Tighten hex nuts securely with ⁷⁄₁₆" wrench.
A. Hex nut
B. Lock washer
C. Flat washer
D. Tray center
E. Carriage bolt
A. Hex nut
B. Lock washer
C. Flat washer
D. Carriage bolt
A
B
C
D
E
A
B
C
D
A. #10 - 12 x 1
¹⁄₂
" slot-head wood screws
A. Angled edge on top of the tray side
B. Notch
A. Bubble indicates the angled edge on top of the tray side is level.
B. Place level on angled edge against notch on tray side.
A
A
B
B
A
Page view 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Comments to this Manuals

No comments