Whirlpool GBS307 Service Manual download pdf (Page 22)

4-2

REMOVING THE THERMAL FUSE, THE OVEN CONTROL/

DISPLAY BOARDS, AND THE TOUCH PANEL ASSEMBLY

1. Disconnect the electrical power to the

double oven.

2. Open the lower oven door.

3. Remove the bottom screw from each of

the two side trim pieces (see below).

4. To remove the side trim, pull the bottom

out approximately 2˝, and slide the top

down to free it from the control panel.

CAUTION: When you work on the double

oven, be careful when handling the sheet metal

parts. Sharp edges may be present, and you

can cut yourself if you are not careful.

6. To remove the oven control panel, pull it

out at the bottom, and lift and unhook it

from the oven cabinet support at the top.

7. Disconnect the wire connectors from the

control board and set the panel face down

on a padded surface to protect the finish.

Electrical Shock Hazard

Disconnect power before servicing.

Replace all panels before operating.

Failure to do so could result in death or

electrical shock.

WARNING

6 Wire Connectors

5. Remove the screws from the oven control

panel.

Control

Panel

Screw

Pull

Out

Oven

Control

Panel

Lift Off

Top

Support

Side Trim Screw

(1 On Each Side)

Pull Out Bottom

Of Side Trim

Pull Side Trim

Down & Away

From Control

Panel

8. To remove the thermal fuse, disconnect

it from the main harness connector.

Thermal Fuse

Harness

Connector

1 ... 21 22 23 ... 59

Comments to this Manuals

No comments