Whirlpool AQC9 4F7 E1M (UK) Instruction for Use download pdf (Page 10)

Start and Programmes

Choosing a Programme

1. Plug the dryer into the electrical socket.

2. Sort your laundry according to fabric type (see Laundry).

3. Open the door and make sure the filter is clean and in place

and the water container is empty and in place (see Maintenance).

4. Load the machine and make sure that the items are not in

the way of the door seal. Close the door.

5. If the ON/Off light is not lit; press the On/Off Button .

6. Select the Programmes selection that corresponds with

fabric being dried by checking the Programmes table (see

Programmes) as well as the indications for each type of

fabric (see Laundry).

7. Where available, choose Sensor Dry or Timed Dry

option pressing and releasing the corresponding button until

the desired level or time is displayed.

! See programmes table, for more details.

8. Set a delay time and other options as necessary (see The Display).

9. If you wish the buzzer to sound at the end of the

programme, press the sound button . If you have selected

the Crease Care option, this option is not available.

10. Press the START button to begin. The display will

show the estimated time to end.

During the drying programme, you can check on your

laundry and take out the items that are dry while the others

continue drying. When you close the door again, press

Special Programmes

Easy Iron Programme

Easy Iron is a short 10 minute programme (8 minutes of heat followed by a 2 minutes cool tumble period) which fluffs the fibres of

clothing that has been left in the same position/location for an extended period of time. The cycle relaxes the fibres and makes them

easier to iron and fold.

! Easy Iron is not a drying programme and should not be used for wet articles of clothing.

For best results:

1. Do not load more than maximum capacity. These numbers refer to dry weight:

Fabric: Max

Cotton and Cotton mix 2.5 kg

Synthetics 2

Denim 2

2. Unload the dryer immediately after the end of the drying cycle, hang, fold or iron the articles and put them away in the closet.

Should this not be possible, repeat the cycle.

The Easy Iron effect varies from one fabric to the next. It works very well on traditional fabrics like Cotton or Cotton mix, and less

well on acrylic fibres and on materials such as Tencel.®

Wool Programme

• This is a programme for tumble dryer safe garments marked with the symbol .

• It can be used for load sizes up to 1 kg (approximately 3 sweaters).

• We recommend that garments are turned inside out before drying.

• Loads dried using this programme are usually ready to wear, but on some heavier garments the edges may be slightly

damp. Allow these to dry naturally as over-drying could damage garments.

! Unlike other materials, the mechanism of wool shrinkage is irreversible; i.e. it will not stretch back to original size and shape.

! This program is not suitable for Acrylic garments.

Jeans

• This is a programme for Jeans made from Denim Cotton. Before drying your Jeans turn the front pockets inside out.

• It can be used for load sizes up to 3 kg (approximately 4 pairs).

• It can also be used on other garments made from same material such as jackets.

• Loads dried using this programme are usually ready to wear; the edges or seams may be slightly damp. If this is found try turning

the jeans inside out and running the programme again for a short period.

• The duration of this programme will depend on the size of the load, the dryness setting selected and the spin speed used in

your washer.

• Use this cycle only for a 100% cotton load, do not mix dark and light coloured items. Do not use this cycle for garments with

embroidery and accessories (pins,...), turn the pockets insideout

! We do not recommend that you use this programme if your jeans have elastic waist bands or embroidery.

START in order to resume drying.

If you open the door to check your laundry you will extend the

drying time as the heat pump compressor will not start until 5

minutes after you close the door and pressed the start Button

(see The Controls).

11. During the last few minutes of Drying Programmes before

the programme is completed, the final COOL TUMBLE phase

is entered (fabrics are cooled), this phase should always be

allowed to complete.

12. To let you know that your programme is complete the

buzzer will beep 3 times and the display shows END (Note:

if the SOUND option was selected the buzzer beeps 3 times

every 30 seconds for 5 minutes).Open the door, take your

laundry out, clean the filter and replace it. Empty the water

container and replace it (see Maintenance).

If the Crease Care option has been selected and you do

not take the clothes out immediately the clothes will tumble

occasionally for 10 hours or until you open the door.

13. Switch dryer off using the On/Off button.

Standby mode

This tumble dryer, in compliance with new energy saving

regulations, is fitted with an automatic standby system which is

enabled after about 30 minutes if no activity is detected. Press

and hold the On-Off button until the dryer reactivates.

1 ... 9 10 11 ... 20

Comments to this Manuals

No comments

Whirlpool AQC9 4F7 E1M (UK) Instruction for Use Page 10

Comments to this Manuals

Related products and manuals for Tumble dryers Whirlpool AQC9 4F7 E1M (UK)