Whirlpool AWZ 9CD S/PRO Use and Care Guide download pdf (Page 27)

Below is a summary of possible failure causes and

solutions.

If the problem persists after having followed the

instructions as indicated below, press and hold

On/O for at least three seconds. If afterwards the

failure indication still appears, switch o and unplug

the dryer and contact our After-Sales Service.

Display message Possible Cause Solution

F01 to F04 Failure of a component Press and hold On/O for at least 3 seconds.

F05 to F09 Failure of a component Switch off and unplug the dryer. Immediately

open the door and take out the laundry, so that

the heat can dissipate.

Make sure that the ambient temperature ranges

between 5°C and 35°C. Wait for about an hour.

Plug in the dryer, load the laundry and start the

programme again.

If the failure persists, call the After-Sales Service.

F10 to F24 Failure of a component Switch off and unplug the dryer. Wait for about half

an hour. Plug in the dryer and start the programme

again.

If the failure persists, call the After-Sales Service.

TRANSPORT AND HANDLING

Unplug the dryer.

2. Make sure that door and water tank are

properly closed.

3. If the drain hose is connected to your sewage

system, x the drain hose on the rear of the dryer

again (see Installation Guide).

WARNING

Never lift the dryer by

holding it at the worktop.

1 ... 26 27 28 29 30 31 32

No comments

Whirlpool AWZ 9CD S/PRO Use and Care Guide Page 27