7
EN
Finish in
Enables to have the laundry ready at a particular time by
setting a delay until end of the programme.
• Select programme and options.
• Press the “Finish in” button – “Finish in --:--” appears on the display.
• Press the UP or DOWN keys to select a delay up to 23:30 hours.
• Press “Start / Pause” - the countdown of the delay starts. The
display indicates the default programme duration of the selected
programme in the rst line, and the selected “Finish in” period until
programme end in the second line.
• The programme starts automatically, in time to be nished at
the end of the selected “Finish in” period. The second line on the
display keeps on indicating the countdown of the time until end
of the programme.
To cancel the delay
• either press “Start/Pause” to cancel the delay. To start the selected
programme immediately, press “Start/Pause” again .
• or press and hold “On/O” to cancel the complete programme
setting.
INDICATORS
Failure
For any failures, refer to section TROUBLESHOOTING in the USE AND
CARE GUIDE.
Energy monitor
Gives feedback about the energy consumption of the programme
setting.
The less indicators light up, the more economic is your programme
setting.
CARE AND MAINTENANCE
Switch off and unplug the dryer before doing any cleaning and maintenance.
Caution, the water in the water tank can still be hot.
EMPTY WATER TANK AFTER EACH DRYING CYCLE
Hold the handle and carefully pull out the water tank. Hold the full
water tank with both hands.
Empty the water and insert the container by pushing it back into place.
Make sure that it is properly inserted.
CLEAN DOOR FILTER AFTER EACH DRYING CYCLE
Open the door and remove the door lter by pulling it upwards.
Press the button to open the door lter. Remove the lint inside. Close
the lter and reinsert it in the right direction, so that it completely
integrates in the lter chamber.
CLEAN THE BOTTOM FILTER AFTER ABOUT EVERY FIFTH
DRYING CYCLE
Be Careful.
Some models are equipped with dierent lters, therefore some
descriptions below may dier from the lter present in the dryer. All
lters parts have to be cleaned
Open the bottom ap. Hold the handle and
pull out the bottom lter.
Remove the foam from the bottom lter, to
clean it. Clean the lter foam and the lter
by hand or under running water. Do not
wash it in the washing machine. Wring out
the lter foam. Do not insert it in the
bottom lter dripping wet.
Fix the lter foam on the bottom lter.
Clean the lter chamber of the dryer with a
damp cloth or carefully with a vacuum
cleaner. Insert the bottom lter again. Clap
the lter handle down and close the
bottom ap.
Comments to this Manuals