Whirlpool HSCX 80531 Use and Care Guide download pdf (Page 7)

7

EN

Correct replacement are

identied by the colour insert

or the colour embossed in

words on the base of the plug.

Replacement fuse covers

are available from your local

electrical store.

For the Republic of Ireland

only

The information given in

respect of Great Britain will

frequently apply, but a third

type of plug and socket is also

used, the 2-pin, side earth

type.

Socket outlet / plug (valid for

both countries)

If the tted plug is not suitable

for your socket outlet, please

contact After-sales Service for

further instruction. Please do

not attempt to change plug

yourself. This procedure needs

to be carried out by a qualied

technician in compliance with

the manufactures instructions

and current standard safety

regulations.

CORRECT USE

Do not exceed the maximum

load allowed. Check the

maximum load allowed in the

programme chart.

Do not dry unwashed items in

the tumble dryer.

Do not overdry the laundry.

Take care that no lint or dust is

accumulated around the dryer.

Fabric softeners, or similar

products, should be used as

specied by the fabric softener

instructions.

centre.

Do not operate this dryer if

it has a damaged mains cord

or plug, if it is not working

properly, or if it has been

damaged or dropped. Do not

immerse the mains cord or

plug in water. Keep the cord

away from hot surfaces.

The electrical components

must not be accessible to the

user after installation.

Do not touch the dryer with

any wet part of the body

and do not operate it when

barefoot.

ELECTRICAL CONNECTION

FOR GREAT BRITAIN AND

IRELAND ONLY

Fuse replacement.

If the mains lead of this dryer is

tted with a BS 1363A 13amp

fused plug, to change a fuse in

this type of plug use an A.S.T.A.

approved fuse to BS 1362 type

and proceed as follows:

1. Remove the fuse cover (A)

and fuse(B).

2. Fit replacement 13A fuse into

fuse cover.

3. Ret both into plug.

Important:

The fuse cover must be retted

when changing a fuse and

if the fuse cover is lost the

plug must not be used until a

correct replacement is tted.

The dryer is not designed for

built-in installation.

The dryer can be installed

under a worktop, provided

that adequate ventilation of

the dryer is assured. Install

a ventilation grid (minimum

45cm x 8cm), in the rear part

of the worktop under which

the dryer is installed.

ELECTRICAL WARNINGS

Make sure the voltage specied

on the rating plate corresponds

to that of your home.

For installation to comply with

current safety regulations,

an omnipolar switch with

minimum contact gap of 3mm

is required.

Regulation require that the

dryer is earthed.

For dryers with tted plug,

if the plug is not suitable for

you socket outlet, contact a

qualied technician.

Do not use extension leads,

multiple sockets or adapters.

Do not connect the dryer to a

socket which can be operated

by remote control.

The power cable must be

long enough for connecting

the dryer, once tted in its

housing, to the main power

supply.

Do not pull the power supply

cable.

If the power cable is damaged

it must be replaced with an

identical one. The power

cable must only be replaced

by a qualied technician

in compliance with the

manufacturer instruction and

current safety regulations.

Contact an authorized service

1 2 3 4 5 6 7 8 ... 44

Comments to this Manuals

No comments