Whirlpool W10352825A-SP User Manual download pdf (Page 15)

Tighten couplings

Using pliers, tighten the couplings with additional two-thirds

turn.

NOTE: Do not overtighten. Damage to the coupling can result.

Attach short hose and

“Y” connector

If space permits, attach the brass female end of the “Y”

connector to the cold water faucet. See gure A.

If “Y” connector cannot be attached directly to the cold water

faucet, the short hose must be used. See gure B. Attach short

hose to cold water faucet. Screw on coupling by hand until it is

seated on faucet. Then attach “Y” connector to brass male end

of the short hose. Screw on coupling by hand until it is seated

on connector.

Fig. A

Fig. B

Attach long hose to “Y”

connector and tighten couplings

One end of the long hose has a wire mesh strainer inside the

coupling. Attach this end to the “Y” connector. Attach washer

cold inlet hose to other side of “Y” connector. Screw on

coupling by hand until it is seated on connector. Using pliers,

tighten the couplings an additional two-thirds turn.

NOTE: Do not overtighten. Damage to the coupling can result.

Attach long hose to dryer ll

valve and tighten coupling

Attach other end of long hose to ll

valve at bottom of dryer back panel.

Screw on coupling by hand until it

is seated on ll valve connector.

Using pliers, tighten the couplings

an additional two-thirds turn.

NOTE: Do not overtighten. Damage to the coupling can result.

Turn on cold water faucet

Check that the water faucets are turned on.

Check for leaks

Check for leaks around “Y” connector, faucets, and hoses.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

No comments

Whirlpool W10352825A-SP User Manual Page 15