Whirlpool LTE6234DT6 User Manual

27" (69 CM) ELECTRIC WASHER/DRYERINSTALLATION INSTRUCTIONSWASHER/DRYER SAFETYTable of ContentsWASHER/DRYER SAFETY...2N

101. Loosen or remove center, silver-colored terminal block screw.2. Place the hooked end of the neutral wire (white or center wire) of direct wire ca

11Venting RequirementsWARNING: To reduce the risk of fire, this washer/dryer MUST BE EXHAUSTED OUTDOORS.IMPORTANT: Observe all governing codes and ord

12Remove Shipping StrapTo avoid floor damage, set washer/dryer onto cardboard before moving across floor. Move washer/dryer close to its final locatio

13For use with floor drainDo not install the drain hose form onto the corrugated drain hose. You may need additional parts. See Floor drain under “Too

14Plan Vent SystemChoose your exhaust installation typeRecommended exhaust installationsTypical installations vent the dryer from the rear of the wash

15Determine vent path Select the route that will provide the straightest and most direct path outdoors. Plan the installation to use the fewest num

Complete Installation1. Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped.2.

2INSTALLATION INSTRUCTIONSTools and PartsGather the required tools and parts before starting installation. Read and follow the instructions provided w

3Location RequirementsYou will need A location that allows for proper exhaust installation. See “Venting Requirements.” A separate 30-amp circuit.

4Mobile Home - Additional Installation RequirementsThis washer/dryer is suitable for mobile home installations. The installation must conform to the M

5If using a power supply cord:Use a UL listed power supply cord kit marked for use with clothes dryers. The kit should contain: A UL listed 30-amp po

6Electrical ConnectionPower Supply Cord Direct Wire1. Disconnect power.2. Remove the hold-down screw and terminal block cover. 3. Install strain reli

7 Put power supply cord through the strain relief. Be sure that the wire insulation on the power supply cord is inside the strain relief. The strain

81. Remove center, silver-colored terminal block screw.2. Remove neutral ground wire from external ground conductor screw. Connect neutral ground wire

93. Connect ground wire (green or bare) of direct wire cable to external ground conductor screw. Tighten screw.4. Place the hooked ends of the other p