Whirlpool WTW8000BW User Manual download pdf (Page 5)

INSTALLATION INSTRUCTIONS

Before you start: remove shipping materials.

It is necessary to remove all shipping materials for proper

operation and to avoid excessive noise from washer.

NOTE: To avoid oor damage during installation, set the washer

onto cardboard before moving across the oor.

IMPORTANT:

■ Be sure the foam shipping base has been removed from the

bottom of the washer as directed in the “Remove Shipping

Base and Packing Ring” section.

■ If foam shipping base has not been removed, be sure lid is

secured with tape before laying washer on its back.

■ Removing the foam shipping base is necessary for proper

operation.

Place cardboard supports from shipping carton on oor

behind washer for support. Secure the lid with tape. Using

two or more people, tip the washer onto its back and place

on cardboard supports. Remove foam shipping base. Then,

set washer back upright, and remove the tape from the lid

so that you can open the lid and remove the foam packing

ring from the washer tub.

NOTE: Keep foam packing ring in case you need to move

the washer in the future.

1. Remove shipping base

and packing ring

REMOVE SHIPPING BASE

AND PACKING RING

CONNECT DRAIN HOSE

Gently pull hose out of back of washer cabinet from top until

end emerges.

IMPORTANT: Do not force excess drain hose back into rear

of washer.

Remove drain hose from washer

cabinet

IMPORTANT: Proper connection of the drain hose helps

to avoid water leakage and damage to your oors. The drain

hose is connected to your washer and is stored inside the

washer cabinet.

1 2 3 4 5 6 7 8 9 10 ... 19 20

No comments

Whirlpool WTW8000BW User Manual Page 5