30
Connect the water supply hose
1.
Carefully screw the hose connection onto the tap,
preferably by hand.
2.
Make sure there are no kinks in the hose.
3.
Check water-tightness of tap and appliance connections by
turning the tap completely on.
The appliance
must not be
connected to the mixing tap of a
non-pressurized water heater.
The appliance can be connected without a non-return valve.
Check the supply hose regularly for brittleness and cracks and
replace if necessary using a new hose of the same type
(available from After-Sales Service or specialist dealer).
If the flexible hose is damaged, unplug the appliance from
the mains immediately.
Water supply hose A
If the hose is too short, replace it with a suitable length of
pressure resistant hose (minimum 1000 kPa - EN 50084
approved type).
Mount the new hose professionally on the washing machine
and the tap.
Water supply hose B
If the hose is too short, replace it with a longer length of
Water Stop hose (available from After-Sales Service or
specialist dealer).
Mount the new hose professionally on the washing machine
and the tap.
Note: The inlet hose and the plastic enclosure at the water
connection contain electrical components.
For this reason,
do not cut the hose and do not immerse the plastic
enclosure in water.
Connect the water drain hose
1.
Connect the drain hose to the ventilated siphon or hook it over the edge of a sink with the U bend.
2.
Make sure there are no kinks in the hose.
3.
Secure the hose so that it cannot fall down while the appliance is running.
Small wash-hand basins are unsuitable.
If you need to add an extension, use a hose of the same type. Secure the connections with clips.
Max. drain hose length: 2.50 m
Max. drain height: 1.25 m
Min. drain height: 0.70 m
A
B
3gb15098.fm Page 30 Friday, November 14, 2003 4:48 PM
Black process 45.0° 100.0 LPI
Comments to this Manuals