Whirlpool AWT 2256 Instruction for Use download pdf (Page 14)

Water stop anti-flooding system

(depending on model)

•

Screw the hose to the water supply tap. Turn the tap fully

on and check the water-tightness of the connection.

•

The appliance must not be connected to the mixing tap of

a non-pressurized water heater!

•

The inlet hose and the plastic enclosure contain electrical

components: Do not cut the hose and do not immerse the

enclosure in water.

•

If the flexible hose is damaged, unplug the appliance

from the mains immediately and replace it.

If the flexible hose is too short, replace it with a 3 m Water

Stop hose (available from After-Sales Service or from your

dealer). This operation must be carried out exclusively by a

qualified technician.

Connect the water drain hose

Unhook the drain hose from the left and right hose

connections, see arrow A in figure.

Important:

Do NOT loosen the drain hose connection from the left

side, see arrow B in figure.

Otherwise, there is the risk of

leakage and of scalding with hot water.

Fix the “U” bend (

) to the free end of the drain hose.

Connect the drain hose to the siphon or hook it over the

edge of a sink with the “U” bend.

Small hand basins are not suitable.

The edge of the sink must be no more than 100 cm from

the floor.

If you need to add an extension, use a flexible hose of the

same size and secure the unions with screw-on hose clips.

Maximum overall drain hose length: 2.50 m.

Maximum drain height (“U” bend): 100 cm.

Minimum drain height: 55 cm.

Important:

Make sure there are no kinks in the drain hose and take

precautions against it falling while the appliance is running.

1 2 ... 9 10 11 12 13 14 15

No comments

Whirlpool AWT 2256 Instruction for Use Page 14