Whirlpool CAM2742TQ2 Owner's Manual download pdf (Page 2)

Check location where washer will be

installed. Proper installation is your

responsibility. Make sure you have

everything necessary for correct

installation.

Do Not store or operate washer below

32°F (0°C) (some water may remain in

washer).

Hot and cold water faucets: Must be

within 4 feet (1.2 meters) of the back

of the washer and provide water

pressure 10 - 100 PSI (69-690 kPa). A

pressure reduction valve should be

used in the supply line where inlet

pressure entering the building

exceeds 100 PSI (690 kPa) to prevent

damage to the washer mixing valve.

Grounded

electrical outlet

is required. See

Electrical

requirements.

Single washer

installations require

12-inch (30 cm)

minimum risers to

provide an air

cushion and

prevent noise and

damage to valves.

Untape and

open washer

lid. Remove

packages and

hoses from

washer.

Water heater: Set to

deliver 120°F (49°C)

water to the washer.

Standpipe drain system: Needs a two-

inch (5 cm) minimum carry-away

capacity of 17 gallons (64.4 liters) per

minute. Top of standpipe must be at

least 39 inches (99 cm) high and no

higher than 72 inches (183 cm) from

bottom of washer.

Level floor: Maximum slope

under washer — 1 inch (2.5 cm).

Front access to the pump area is

available by removing 2 No. T20

Torx screws and then removing the

front panel.

Support: Floor must be sturdy

enough to support loaded washer

weight of 315 pounds (143 Kg).

A floor drain should be

provided under the bulkhead.

Prefabricated bulkheads with

electrical outlets, water supply

lines and drain facilities should

be used only where local

codes permit.

Important: Observe all governing

codes and ordinances.

PAGE 2

Before you start...

We have provided many important

safety message in this manual and

on your appliance. Always read

and obey all safety messages.

WARNING

This is the safety alert symbol.

This symbol alerts you to

potential hazards that can kill or

hurt you and others.

All safety messages will be preceded

by the safety alert symbol and the

word “DANGER” or “WARNING”.

These words mean:

All safety messages will tell you

what the potential hazard is, tell you

how to reduce the chance of injury,

and tell you what can happen if the

instructions are not followed.

You can be killed or seriously

injured if you don’t immediately

follow instructions.

You can be killed or seriously

injured if you don’t follow

instructions.

DANGER

Your safety and the safety of others are very important.

No. T20 TORX

®

screws

® Registered trademark of TEXTRON

1 2 3 ... 16

Comments to this Manuals

No comments