Whirlpool FSCR80410 Use and Care Guide download pdf (Page 45)

DOOR – HOW TO OPEN IT IN CASE OF A

FAILURE, TO TAKE OUT YOUR LAUNDRY

(IF FEATURE IS AVAILABLE)

Before opening the door as described in below

section, refer to failure “Door is locked with or

without failure indication, and the programme

does not run”. The door may unlock by itself after

conditions like for example a power breakdown do

not persist anymore.

If you want to take out your laundry immediately,

rst try to unlock the door as described in FAILURE

INDICATORS AND MESSAGES (FdL or F29). Only

if the door cannot be opened as described in the

section mentioned before, proceed as described

below.

In case of a power breakdown, the washing

machine will proceed where it was interrupted as

soon as power is available again.

If a failure occurs on the washing machine and the

door is locked, but you must take out your laundry:

1. First drain the residual water, as described in

section “Draining residual water”

2. Remove the screw with a screwdriver.

3. Then pull downwards the strap marked with

“Door open”. You can now open the door and take

out your laundry.

4. Afterwards x the strap again by rmly turning

in the screw with the screwdriver.

5. Reinstall the plinth

Switch o the washing machine and unplug it.

Close the water tap.

Wait until the drum has stopped rotating.

Never open the door while the drum is in

motion.

Wait until water and laundry have cooled down

when washing with high temperatures.

Always drain the water before opening the

door, either by pressing and holding On/O

until "rES" appears on the display, or by doing

it manually as described in section DRAINING

RESIDUAL WATER.

1 ... 44 45 46 ... 54

No comments

Whirlpool FSCR80410 Use and Care Guide Page 45