26
a.
Water inlet fault (no
water or insufficient
water pressure)
The Water tap closed indicator
is on and the digital display
shows FH Switch off the
appliance by turning the
programme selector to the
position and unplug it.
Check whether:
the water tap is open and the
water supply pressure is
sufficient;
the water inlet hose is kinked;
the mesh filter between the
tap and the hose is clean (see
Care And Maintenance/
Mesh filter in water
connection);
the water supply hose is frozen
up.
Connect the appliance to the
electrical supply.
Reselect the desired programme
and press the
Start/Pause
button again to continue with
the programme (do not add
detergent for this programme).
b.
Draining fault
The digital display shows FP.
Switch off the appliance by
turning the programme selector
to the position and unplug
it.
Check whether:
the drain hose is kinked (see
Installation);
IMPORTANT:
before draining,
make sure that the water has
cooled down.
the drain hose is frozen.
Connect the appliance to the
electrical supply.
Reselect the desired programme
and press the
Start/Pause
button again to continue with
the programme (do not add
detergent for this programme). If
the fault re-occurs, contact After-
Sales Service (See After-Sales
Service).
the pump or the foreign body
trap (if fitted on your
appliance) is blocked.
See Removing the filter, in
the previous chapter.
c.
Electrical module fault
The digital display shows F4 to
F21.
Set the programme selector to
the position, select the
desired programme and press
the
Start/Pause
button
again. The programme will
continue.
If the fault re-occurs, contact
After-Sales Service (See After-
Sales Service).
d.
Water Stop fault
An audible tone sounds. The
light of the Water Stop indicator
goes on. The digital display
shows FA and the pump is
running.
The Water Stop fault may
have been triggered by:
too much foam.
a leak in the appliance, water
running into the water tank.
1.
Switch off the appliance by
turning the programme
selector to the position,
unplug the appliance and
turn off the tap.
2.
Tilt the appliance forwards
carefully to allow the collected
water to flow out,
3.
plug the washing machine in
again and turn on the tap,
4.
reselect the desired
programme and press the
Start/Pause
button (there
is no need to add additional
detergent). The programme
will continue. If the faults
occurs again, call After-Sales
Service with details about the
fault (see After-Sales
Service),
5.
If the
Start/Pause
button is
not pressed but water is still
flowing into the machine, turn
off the water supply and
inform After-Sales Service (see
After-Sales Service).
4gb15270.fm Page 26 Friday, November 14, 2003 4:49 PM
Black process 45.0° 100.0 LPI
(8 pages)
(60 pages)
(15 pages)
(60 pages)
(8 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals