Before Using The Washing Machine
1. Remove the packaging
and check
•
After unpacking, make sure
that the washing machine is
undamaged. If in doubt, do
not use the washing
machine. Contact After-
Sales Service or your local
retailer
•
Check that the accessories
and supplied parts are all
present
•
Keep the packing material
(plastic bags, polystyrene
parts, etc.) out of reach of
children, as they are
potentially dangerous
2. Remove the transport
bolts
•
The washing machine is
fitted with a transport bolts
to avoid any possible
damage to the interior
during transport. Before
using the washing machine,
it is imperative that the
transport bolts are removed
3. Install the washing
machine
•
Remove the protective foil
from the control panel
•
Move the appliance without
lifting it by the worktop
•
Install the appliance on a
solid and level floor surface,
preferably in a corner of the
room
•
Make sure that all four feet
are resting firmly on the
floor and check that the
appliance is perfectly level
(use a spirit level)
4. Water inlet
•
Connect the water supply
inlet hose in accordance
with regulations of your
local water company
5. Drain hose
•
Connect the drain hose to
the siphon or hook it over
the edge of a sink by means
of the “U” bend supplied
•
If the washing machine is
connected to a built-in
pumping out system, ensure
that the latter is equipped
with a vent to avoid
simultaneous loading and
draining of water (siphoning
effect)
6. Electrical connections
•
Electrical connections must
be carried out by a qualified
technician in compliance
with the manufacturer’s
instructions and local safety
regulations
•
Data concerning voltage,
consumption and fuses are
located on the inside of the
appliance door
•
The appliance must be
connected to the mains
exclusively by means of a
socket with an earth
connection in accordance
with established regulations.
The washing machine must
be earthed by law. The
manufacturer declines all
liability for damage to
property or injury to persons
or animals due to non-
compliance with the
directions given above
•
Do not use extension leads or
multi sockets
•
Before any maintenance on
the washing machine
disconnect it from the mains
supply
•
Access to the mains plug or to
disconnection from mains
supply via a double-pole
switch must be ensured at all
times following the
installation
•
Do not operate the washing
machine if it has been
damaged during transport.
Inform the After-Sales Service
•
Mains cable replacement is
only to be carried out by
After-Sales Service
•
The washing machine must
only be used in the
household for the prescribed
uses
Minimum housing
dimensions:
Width: 600 mm
Height: 825 mm
Depth: 600 mm
•
Water inlet: Cold water only
•
Tap: 3/4” threaded
hose
connection
•
Water
pressure
(flow
pressure):
100-1000 kPa
(1-10 bar)
4gb15136.fm5 Page 2 Monday, October 13, 2003 4:18 PM
(36 pages)
(36 pages)
(2 pages)
(8 pages)
(8 pages)
(40 pages)
(60 pages)
(48 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals