Whirlpool 66121559A Use and Care Guide download pdf (Page 11)

AIR CONDITIONER USE

Operating your air conditioner properly helps you to obtain the

best possible results.

This section explains proper air conditioner operation.

IMPORTANT:

■ If you turn off the air conditioner, wait at least 3 minutes

before turning it back on. This prevents the air conditioner

from blowing a fuse or tripping a circuit breaker.

■ Do not try to operate your air conditioner in the cooling mode

when outside temperature is below 65°F (18°C). The inside

evaporator coil will freeze up, and the air conditioner will not

operate properly.

NOTE: In the event of a power failure, your air conditioner will

operate at the previous settings when the power is restored.

Starting Your Air Conditioner—Digital Control

NOTES:

■ When the air conditioner is off, the display shows the current

room temperature.

■ If the room temperature is below 55ºF (13ºC), the display will

show 55ºF (13ºC). If the room temperature is above 99ºF

(37ºC), the display will show 99ºF (37ºC).

1. Remove clear protective film from control panel and front

panel badge (on some models).

2. Press POWER to turn on the air conditioner.

NOTE: When air conditioner is turned on for the first time

after it is plugged in, it will display the default settings: Cool

mode, Turbo fan speed, 72°F (22°C) for 3 seconds. When it is

turned on at all other times, it will display the previous

settings for 3 seconds, and then display the room

temperature.

3. Select mode. See “Mode.”

4. Select fan speed. See “Fan Speed.”

5. Set temperature. See “Temperature.”

Mode

1. Press and hold MODE until you see the indicator light for the

desired setting.

2. Choose Cool, Fan Only or Power Saver.

■ Cool—Cools room. Press FAN SPEED to choose fan

speed. Press the up or down arrow buttons to adjust the

temperature.

■ Fan—Operates the fan at Turbo speed, without cooling.

The display shows “FO” (fan only).

■ Power Saver—Fan runs only when cooling is needed. You

can select the fan speed by pressing Fan Speed.

Because the fan does not circulate the room air

continuously, less energy is used, but the room air is not

circulated as often. Use Power Saver when you are

asleep or away from home.

Fan Speed

NOTE: The Fan Speed button will operate only when the Cool or

Power Saver mode has been selected.

1. Press and hold FAN SPEED until you see the indicator light

come on for the setting you desire.

2. Choose Turbo, High, Low or Auto.

Filter Monitor

1. When filter indicator light is lit or flashing, remove, clean and

replace air filter. See “Cleaning the Air Filter.”

2. Press and hold FILTER for 3 seconds after cleaning and

replacing the air filter. This resets the filter monitor.

NOTE: After 360 hours of fan operating time, the filter indicator

light will turn on. It will remain on for 180 hours or until you press

FILTER. After 180 hours, it will flash. It will continue flashing until

you press FILTER.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

Comments to this Manuals

No comments

Whirlpool 66121559A Use and Care Guide Page 11

Comments to this Manuals

Related products and manuals for Window & through-wall air conditioners Whirlpool 66121559A