Whirlpool UXB0600DYS Specifications download pdf (Page 4)

4. Install the 6 mm nuts to the outside top or outside back

(alternate location on some models) of the range hood at the

proper location for the selected motor system.

■ Two 6 mm nuts are required for the single motor system.

Clip nuts into the small square notches located at the left

and right end of the square vent opening.

■ Five 6 mm nuts are required for the dual motor system.

Clip nuts into the small square notches, one located in the

front of the square vent opening and the other four

located at the left and right ends of the square vent

opening.

5. Mount range hood using the Installation Instructions that

came with your range hood model.

Install Range Hood Blower Motor

1. Install the range hood blower motor assembly inside the

range hood canopy with the wiring connection to the left for

the single motor system and to the front or top for the dual

motor system.

Single Blower Motor Assembly

Dual Blower Motor Assembly

2. Slide the left mounting plate flange under the motor mounting

bracket.

3. Run the power supply wires and connector from the range

hood through the hole in the right end of the motor mounting

plate.

A. Clip nut (6 mm) locations for dual motor assembly (quantity 5)

B. Clip nut (6 mm) locations for single motor assembly (quantity 2)

A. Wiring connection

A. Motor mounting bracket

B. Mounting plate left flange

A. Motor mounting plate hole

B. Power supply wires and connector

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Whirlpool UXB0600DYS Specifications Page 4