NATURAL GAS TO PROPANE CONVERSION KITALPKT572-2 INSTALLATION INSTRUCTIONSPROPANE CONVERSION KIT SAFETYTable of ContentsPROPANE CONVERSION KIT SAFETY..
10Make Gas Connections1. Install the field gas supply as shown.2. Provide a sediment trap on the outside of the furnace.3. Install a manual gas shutof
11Adjust the Furnace Input Rate (if required)IMPORTANT: Follow these instructions for the altitude of your installation. Above 10,000 ft: Furnace is
Complete InstallationIMPORTANT: Do not use this furnace if any part has been under water. Immediately call a qualified person to inspect the furnace a
2ADDITIONAL SAFETY INFORMATIONINSTALLATION REQUIREMENTSThese instructions are intended as a general guide only and do not supersede any national or lo
3INSTALLATION INSTRUCTIONS\Remove Low NOx Inserts(on some models)This section refers only to models that contain an “L” in the full model number. If y
47. Remove the screws fastening the low NOx inserts to the panel. The tabs attached to the low NOx inserts will remain on the inserts.8. Slide the low
56. Remove the regulator adjustment cap with “O” ring, pressure regulator adjusting screw, and spring from the gas control valve. See “Gas Control Val
6Closed Burner Box Furnace ConversionIMPORTANT: This section refers only to models WFCU, GID80AR, GID80AT, GID91AU, and CG90UA.1. Turn off gas supply
79. Convert the Gas Control Valve for LP Gas. Open the plastic bag included in this kit. Locate the new spring (different color) and install. Locat
8Horizontal Furnace ConversionIMPORTANT: This section refers only to models WFCH, CG90HA, and GID90AH. LP adapter plates are not required for these mo
910. Remove the regulator adjustment cap with “O” ring, pressure regulator adjusting screw, and spring from the gas control valve. See “Gas Control Va
Comments to this Manuals