IMPORTANT: Save for local electrical inspector’s use.INSTALLATION INSTRUCTIONS30" (76.2 CM) FREESTANDING GAS RANGEwith standard clean ovenW100320
10Check OperationElectronic Ignition SystemCooktop and oven burners use electronic ignitors in place ofstanding pilots. When a cooktop control knob is
113. Locate the air shutter near the rear wall of oven and loosenthe shutter screw.4. Adjust the air shutter. 5. Turn the oven back on and check for p
122. Unplug or disconnect power.3. Open broiler door and remove broiler pan. The gas pressureregulator is located in the back right hand corner of the
2. Locate LP gas orifice spuds for top burners in the bagcontaining literature included with the range. Three LP gasspuds are stamped “88” and one “96
142. Locate the natural gas orifice spuds for the top burners in thebag containing literature included with the range. Threenatural gas spuds are stam
To Convert Oven Burner1. Open oven door and remove oven racks, oven tray, flamespreader and set aside.2. Lift oven burner. The orifice spud is behind
W10032050©2006 Whirlpool CorporationAll rights reserved.Printed in Mexico07/2006
2You can be killed or seriously injured if you don't immediately You can be killed or seriously injured if you don'tfollow All safety messa
3WARNING: If the information in this manual is not followed exactly, a fire or explosionmay result causing property damage, personal injury or death.–
4INSTALLATION REQUIREMENTSTools and PartsGather the required tools and parts before starting installation.Read and follow the instructions provided wi
Installation ClearancesCabinet opening dimensions shown are for 25" (64 cm)countertop depth, 24" (61 cm) base cabinet depth and 36" (91
Gas Supply RequirementsObserve all governing codes and ordinances.IMPORTANT: This installation must conform with all local codesand ordinances. In the
7†®TEFLON is a registered trademark of E.I. Du Pont De Nemours and Company.Flexible metal appliance connector: If local codes permit, a new CSA desig
8INSTALLATION INSTRUCTIONSUnpack Range1. Do not use oven door handle to lift or move the range. 2. Remove shipping materials, tape and protective film
9Make Gas ConnectionTypical rigid pipe connectionA combination of pipe fittings must be used to connect the rangeto the existing gas line. Your connec
Comments to this Manuals