Whirlpool ADG 6240/1 FD Instruction for Use download pdf

EN -1-

Chart

PROGRAM SELECTION

BUTTON

Push “P” button (repeatedly)

until selected program number

is shown on the display

(P1...Px) - see “Table of

programs” below.

(see at right for options description)

START/RESUME BUTTON

Push this button to start the selected program: the

indicator lights up and goes off at the end of the program.

When the door is opened during a washing cycle, the

cycle is temporarily paused: the Start indicator blinks.

To resume the cycle push Start button and close

the door within 3 seconds.

CANCEL/OFF BUTTON

Push this button to switch off the control panel.

If pressed when a program is running it cancels the

program ongoing draining water for 1 minute

(0:01 is shown into the display).

If pressed when the dishwasher is switched off,

it drains any possible liquids from dishwasher

(1 minute process).

1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additional options) and may vary depending on conditions.

Differences of up to 20 minutes are possible with sensor programs as a result of the appliance’s automatic calibration system.

2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the EN/Standard loading comparison test

and other tests, contact the following address: “nk_customer@whirlpool.com”.

3) The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on the NF EN 13697 standard of November 2001.

RECYCLING WATER SYSTEM: these programs save water in a dedicated tank.

A TANK CLEANING CYCLE (at least 45 min.) is automatically run every 30 cycles or after every power off, to assure the best product conditions.

Table of programs

Deter-

gent

Consumption

Drying

Phase

Programs

Available

options

Loading instructions

Litres kWh

Minutes

Sensor 40-70°C

Delay

Multizone

Recommended program for routine

washes, with dried-on food

(e.g. EN 50242).

X 7-14 1.00-1.65 80-165 Full

Pre-Wash cold

Delay

Multizone

Crockery to be washed later.

— 4.0 0.03 14 NO

Fragile 40°C

Delay

Multizone

Light soiling, for example glasses and

cups.

X 10.0 0.85 100 Light

Rapid 45°C

Delay

Multizone

Lightly soiled crockery, with no dried-on

food.

X 11.0 0.80 30 NO

Eco

50°C

Delay

Multizone

Normally soiled crockery.

Energy-saving program.

X 6.0 1.03 185 Full

Fast Daily 60°C

Delay

Multizone

Normally soiled crockery.

X 10.0 1.30 80 Full

Silent 50°C

Delay

Multizone

Normally soiled crockery, gentle and

quiet thanks to the lower spray pressure

(39 dbA).

X 10.0 1.20 290 Light

Intensive 65°C

Delay

Multizone

Recommended program for heavily soiled

crockery, especially suitable for pans and

saucepans.

X 11.0 1.60 145 Full

Steam

Delay

Multizone

Program including steam action dedicated

for heavily soiled crockery, pots and pans.

Soaking or hand pretreatment is no

longer needed.

X 10.0 1.70 180 Full

P10

Hygiene

Delay

Multizone

Normally or heavily soiled crockery, with

additional antibacterial wash. Program

interruption (e.g. due to door opening)

can compromise elimination of germs.

X 13.0 1.50 118 Full

5019 300 00710

BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS

QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!

Options and display description

WASH TIME DISPLAY

Indicated the cycle duration and the remaining time (h:min). With “Delayed start” selected it indicates

the time remaining until program start (h.00) - below 1h (0:min).

If “Fx Ey” messages appears on the display, see page 6 - chapter “What to do if...”.

THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY

BUTTON EXCEPT CANCEL/OFF BUTTON. FOR ENERGY SAVING THE

CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER 30 SECONDS IF

NO CYCLE HAS STARTED.

OPERATION

INDICATOR

A LED light projected

on the floor indicates

that the dishwasher is

working.

TABLET SETTING

This setting allows to optimize the cycle performances

according the type of detergent used.

Push the Tablet button for 3 seconds (until the indicator lights

up) if you are using the combined detergents in tablet (rinse aid,

salt and detergent in 1 dose).

If you are using powder detergent or liquid detergent, the

Tablet indicator on the control panel has to be off.

DELAYED START BUTTON

Push the button (repeatedly)

to delay the start of the

program. Adjustable from 1 to

24 hours. With each press of

the button, the delayed start

indicator increases by one

hour and after 24 restarts from

0. Then press the START

button. The dishwasher will

start after the set time.

MULTIZONE

Allows you to choose the washing

zones. Press this button (repeatedly)

to select the wash zones:

both racks

only lower rack

only upper rack

- indicator lits

RINSE AID

INDICATOR

When lit (at the end of

the cycle), the rinse aid

dispenser needs to be

refilled.

SALT INDICATOR

When lit (at the end of

the cycle), the salt

reservoir needs to be

refilled.

Quick reference guide

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - 5019 300 00710

EN -1-ChartPROGRAM SELECTION BUTTONPush “P” button (repeatedly) until selected program number is shown on the display (P1...Px) - see “Table of progra

Page 2 - Daily check

EN -2-First time use5 78614109231- salt reservoir2- rinse aid dispenser3- detergent dispenser4- racks system5,6,7,8- available functions on the pan

Page 3 - Daily use

EN -3-Daily check3Check the rinse aid indicator to check the level into the dispenser.(depending on the model)Rinse aid indicator on the control panel

Page 4 - Rotate the flap

EN -4-How to load the racksCLICK!Rotate the flapclockwise andhook on rackCLICK!HGD - OPENLOWER RACK - depending on the model4B - Cutlery basket: can b

Page 5 - Maintenance and care

EN -5-Switching off the appliance. Everything OK...Wash cycleSelect program678Maintenance and careMaintenance and careOverview of programsThe max. pos

Page 6 - What to do if

EN -6-What to do if...If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem.Most fault

Page 7

EN -7-What to do if...Crockery and cutlery... Possible causes... Solutions...salt indicator lit - Use tablets for soft water. - Set “Tablet” option

Page 8

EN -8-What to do if...If, after carrying out the above checks, the fault persists, disconnect the mains plug and turn off the water tap. Contact the A