Whirlpool WP 75/4 Instruction for Use download pdf

Whirlpool is a registered trademark of Whirlpool USA

5019 396 01120

Before using the dishwasher, read the

installation and maintenance instructions carefully!

WP 75

1) Programme data obtained in conformity with European standard EN 50242. The data may vary according to different loads,

different extra functions, different sensor settings (for sensor programmes only), different water supply temperatures, different

water hardnesses, different power supply voltages, etc.

2) Reference programme for energy label in compliance with EN 50242. - Important information for Test Laboratories:

for

detailed information on the EN/Standard loading comparison test and other tests, contact the following address:

“nk_customer@whirlpool.com”.

3) The antibacterial action has been shown in collaboration with the Pasteur Institute, Lille (France), in conformity with.

Standard NF EN 13697 - November 2001.

1. OVERVIEW

On button

Off button

Programme selection button

Press button P (repeatedly) to bring up the number of

the desired programme on the display.

Time and failure display

With normal operation, the display indicates residual

time (h:mm), while with the “Delayed start” function

selected it indicates time remaining until the start of the

programme (hh).

If “F..” appears on the display, see chapter “5. What to do

if...”.

Rinse aid level indicator and salt level indicator

These indicator lamps light up when rinse aid or salt

need to be added. Add just before starting a wash

programme.

Select detergent

Press the button repeatedly to select the type of

detergent used.

This deactivates the rinse aid and/or salt indicator lamp.

Half Load/Multizone Button

The half load cycle can be used for the upper or lower

rack. Select the required programme then press the “Half

load” button. The light comes on and goes off at the end

of the programme. This function can be used with the

programmes indicated in table 1.1.

Powder, gel, tab (standard): indicator off

Detergent with rinse aid: left indicator

Detergent with salt + rinse aid: right indicator

Antibacterial rinse

This function activates an antibacterial rinse at the end of

the wash cycle, guaranteeing a further reduction of

bacteria. Press the button to activate or deactivate the

function. This function can be used with those

programmes marked with the relative symbol in table 1.1.

The dishwasher door must be kept shut for the entire

duration of the programme in order to guarantee

reduction of bacteria. If the door is opened the indicator

lamp starts flashing.

“Delayed start” button

Press the button repeatedly to delay the start of the

programme. Delay adjustable from 1 to 24 hours. With

each successive touch of the button, the delayed start

indicator increases by one hour and after 24 returns to

00. Then press the START button. The dishwasher will

start at the set time.

START button

Switches “on” when the dishwasher is operating. Flashes

when a fault occurs. Switches off at the end of the

programme.

Reset button - for changing programme or failure display

Press this button to cancel a started programme and

selected options. Press this button to cancel the main

fault indicators (F..), for fault details consult chapter “5.

What to do if...”. A new programme can then be selected

and started.

Table 1.1.

Programme chart

Detergent

dispenser

Consumption

Programmes

Selectable

extra

functions

Loading instructions large small Litres kWh Minutes

Pre-Rinse cold

Crockery to be washed later. — — 5.0 0.02 10 ±

Quickwash 40°C

Lightly soiled crockery, with no

dried-on food.

X — 13.0 0.70 30 ±

Eco

50°C

Normally soiled crockery. Energy

saving programme.

X X 15.0 1.05 165 ±

Daily 60°C

Normally to heavily soiled crockery. X X 16.0 1.35 120 ±

Intensive 70°C

Recommended programme for

heavily soiled crockery, especially

suitable for pans and saucepans.

X X 17.0 1.65 145 ±

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - 1. OVERVIEW

Whirlpool is a registered trademark of Whirlpool USA5019 396 01120Before using the dishwasher, read the installation and maintenance instructions care

Page 2 - 2. QUICK REFERENCE GUIDE

22. QUICK REFERENCE GUIDEDetailed instructions are given in the following pages, see also chapter “5. What to do if...”1. Switch on the applianceOpen

Page 3 - 3. HOW TO USE THE APPLIANCE

33. HOW TO USE THE APPLIANCEPROGRAMME SELECTIONPress the button or to bring up the desired programme on the display. The appliance must be switche

Page 4

43. HOW TO USE THE APPLIANCEc. How to adjust the rinse aid dosage regulatorThe rinse aid dosage can be adjusted to the detergent used. The lower the s

Page 5

53. HOW TO USE THE APPLIANCEHOW TO LOAD THE RACKSUPPER RACK - depending on the modelLong-handled utensils (kitchen knives) must be arranged with the s

Page 6

64. PRECAUTIONS AND GENERAL RECOMMENDATIONS1. PackingThe packaging materials are 100% recyclable and marked with the recycling symbol. .2. Removing t

Page 7 - 5. WHAT TO DO IF

75. WHAT TO DO IF...If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem. Most faults

Page 8

85. WHAT TO DO IF...Crockery and cutlery ... Possible causes/solutions...are not perfectly clean/have food residues- In the event of frequent use of t