Whirlpool ADP 3T Instruction for Use download pdf

-1-

Chart

PROGRAMME

SELECTOR

KNOB

(see “Table of

programmes”

below).

START

DELAY

option

MULTI

ZONE

option

ANTI-

BACTERIAL

RINSE

option

ON/OFF

BUTTON

START BUTTON

The indicator lights up during operation, flashes when a fault occurs, and goes off

at the end of the programme.

START BUTTON RESET FUNCTION:

Press this button for at least 2 seconds; the selected programme and options will

be cancelled. Main failure displays (repeated flashing of the START indicator lamp)

can be cancelled by RESETTING. Detailed instructions are given in chapter

“What to do if...”.

(see at right for options description)

1) Programme data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additional options) and may vary

depending on conditions. Differences of up to 20 minutes are possible with sensor programmes as a result of the appliance’s automatic calibration system.

2) Reference programme for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the

EN/Standard loading comparison test and other tests, contact the following address: “[email protected]”.

3) The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on the NF EN 13697 standard of November 2001.

Table of programmes

Deter-

gent

Consumption

Programmes

Available

options

Loading instructions

Litres kWh

Minutes

Sensor Intensive 60-70°C

Delay

Multizone

Antibacterial

rinse

Automatic programme recommended

for heavily soiled crockery with dried-

on or burnt food, for example pans

and saucepans.

X 13-20 1.10-2.00 100-150

Sensor Normal 40-55°C

Delay

Multizone

Antibacterial

rinse

Automatic programme recommended

for routine washes, with no dried-on

or burnt food (not for EN 50242).

X 10-13 0.80-1.05 60-120

Pre-Wash cold

Delay

Multizone

Crockery to be washed later. — 4.0 0.03 14

Glasses 40°C

Delay

Multizone

Light soiling, for example glasses and

cups.

X 10.0 0.85 100

Quickwash 40°C

Delay

Multizone

Lightly soiled crockery, with no dried-

on food.

* Use of tablets not

recommended.

10.0 0.65 30

Bio

50°C

Delay

Multizone

Antibacterial

rinse

Normally soiled crockery. X 12.0 1.05 150

5019 396 01753ADP 3T

Options and display description

BEFORE USING THE APPLIANCE FOR THE

FIRST TIME CAREFULLY READ THIS QUICK

REFERENCE GUIDE AND THE INSTALLATION

INSTRUCTIONS! THE GUARANTEE IS NOT

APPLICABLE IF FAULTS ARE CAUSED BY

INCORRECT USE OF THE APPLIANCE.

DELAYED START

BUTTON

Press the button (repeatedly)

to delay the start of the

programme by 3, 6 or 9 hours.

Then press the START button.

The dishwasher will start at the

set time.

HALF LOAD/MULTIZONE

Allows you to choose the

washing zones. Press this button

to select the wash zones:

both racks

only upper rack

only lower rack

ANTIBACTERIAL RINSE

This function activates an

antibacterial rinse at the end of

the wash cycle, guaranteeing a

further reduction of bacteria.

Press the button to activate or

deactivate the function. This

function can be used with

those programmes marked

with the relative description in

table. The dishwasher door

must be kept shut for the

entire duration of the

programme in order to

guarantee reduction of

bacteria. If the door is opened

the indicator lamp starts

flashing.

RINSE AID INDICATOR

When lit, the rinse aid dispenser needs

to be refilled.

SALT INDICATOR

When lit, the salt reservoir

needs to be refilled.

PROGRAMME PROGRESS INDICATOR

Pre-Rinse Washing Drying Programme

end

Quick reference guide

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - 5019 396 01753ADP 3T

GB -1-ChartPROGRAMMESELECTORKNOB(see “Table of programmes” below).STARTDELAYoptionMULTIZONEoptionANTI-BACTERIALRINSEoptionON/OFFBUTTONSTART BUTTONThe

Page 2 - First time use

GB -2-First time use1- salt reservoir2- rinse aid dispenser3- detergent dispenser4- racks system5,6,7,8- available functions on the panel9- filters10-

Page 3 - Daily use

GB -3-Daily check123Adding rinse aid (not necessary when you use tablets). How to adjust the rinse aid dosage regulatorDaily useThe salt level indicat

Page 4

GB -4-A - Two trays forcutlery(In some models only)B - Adjustable glass holderHow to adjust upper rack height (if available) - It could be useful to l

Page 5 - Maintenance and care

GB -5-Rectifying minor faults yourself ...Switch off the appliance Everything o.k. ...Wash cycleSelect programmeQuick, permanent or alternating109678O

Page 6 - What to do if

GB -6-What to do if...If a fault occurs, before restoring normal appliance operation.contacting the After-sales Service, make the following checks to

Page 7

GB -7-What to do if...Crockery and cutlery... Possible causes...Solutions...salt indicator lit- Use tablets for soft water. - Set “Detergent type”

Page 8

GB -8-What to do if...If, after carrying out the above checks, the fault persists, switch off the appliance, disconnect the mains plug and turn off th