Whirlpool ADP 4619 IX Instruction for Use download pdf

-1-

Chart

START

DELAY

option

HALF

LOAD

option

ANTI-

BACTERIAL

RINSE

option

ON/OFF

BUTTON

PROGRAMME

SELECTOR

KNOB

(See programme

chart below)

START BUTTON

The indicator lights up during operation, flashes when a fault occurs, and goes off

at the end of the programme.

START BUTTON RESET FUNCTION:

Press this button for at least 2 seconds; the selected programme and options will

be cancelled. Main failure displays (repeated flashing of the START indicator lamp)

can be cancelled by RESETTING. Detailed instructions are given in chapter

“What to do if...”.

(see at right for options description)

1) Programme data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additional options) and may vary

depending on conditions. Differences of up to 20 minutes are possible with sensor programmes as a result of the appliance’s automatic calibration system

2) Reference programme for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the

EN/Standard loading comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”.

3) The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on the NF EN 13697 standard of November 2001.

Table of programmes

Detergent

Consumption

Programmes

Available

options

Loading instructions Litres kWh

Minutes

AutoSensor 50-65°C

Delay

Half load

Antibacterial

rinse

Recommended programme for

routine washes, with dried-on food

(e.g. EN 50242).

X 13-19 1.15-1.50 100-130

Pre-Wash cold

Delay Crockery to be washed later. — 5.0 0.02 10

Party Glass 40°C

Delay

Light soiling, for example glasses and

cups.

X 13.0 0.90 97

Quickwash 40°C

Delay

Lightly soiled crockery, with no

dried-on food.

* Use of tablets not

recommended.

13.0 0.70 30

Eco

50°C

Delay

Half load

Antibacterial

rinse

Normally soiled crockery. X 15.0 1.05 150

Intensive 70°C

Delay

Antibacterial

rinse

Recommended programme for

heavily soiled crockery, especially

suitable for pots and pans.

X 17.0 1.65 145

DELAYED START

BUTTON

Press the button

(repeatedly) to delay the

start of the programme.

Adjustable from 1 to 24

hours. With each press of

the button, the delayed

start indicator increases by

one hour and after 24

restarts from 00. Then

press the START button.

The dishwasher will start

after the set time.

5019 396 01684ADP 4619

HALF LOAD

The half load cycle can be

used for the upper or

lower rack. Select the

required programme then

press the “Half load”

button. The light comes

on and goes off at the end

of the programme.

This function can be used

with the programmes

marked with the relative

description in table.

ANTIBACTERIAL RINSE

This function activates an

antibacterial rinse at the end

of the wash cycle,

guaranteeing a further

reduction of bacteria. Press

the button to activate or

deactivate the function. This

function can be used with

those programmes marked

with the relative description

in table. The dishwasher

door must be kept shut for

the entire duration of the

programme in order to

guarantee reduction of

bacteria. If the door is

opened the indicator lamp

starts flashing.

RINSE AID INDICATOR

When lit, the rinse aid dispenser

needs to be refilled.

SALT INDICATOR

When lit, the salt reservoir

needs to be refilled.

FAULT INDICATION AND WASH TIME DISPLAY

In normal operation it indicates the remaining time

(h:mm), whereas with “Delayed start” selected it

indicates the time remaining until programme start (hh).

If “F..” appears on the display, see chapter “What to do

if...”.

Options and display description

BEFORE USING THE APPLIANCE FOR THE

FIRST TIME CAREFULLY READ THIS QUICK

REFERENCE GUIDE AND THE INSTALLATION

INSTRUCTIONS! THE GUARANTEE IS NOT

APPLICABLE IF FAULTS ARE CAUSED BY

INCORRECT USE OF THE APPLIANCE.

Quick reference guide

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - 5019 396 01684ADP 4619

GB -1-ChartSTARTDELAYoptionHALFLOADoptionANTI-BACTERIALRINSEoptionON/OFFBUTTONPROGRAMMESELECTORKNOB(See programme chart below)START BUTTONThe indicato

Page 2 - First time use

GB -2-First time use578623SEL14109In order to always ensure the best cleaning results, you NEED to set: DETERGENT type and WATER HARDNESS.1- salt rese

Page 3 - Daily use

GB -3-Daily check123Adding rinse aid (not necessary when you use tablets). How to adjust the rinse aid dosage regulatorDaily useThe salt level indicat

Page 4 - How to load the racks

GB -4-How to load the racksHJ(depending on the model)G - Foldable plate holders: They can be folded down to load potsorH- Fixed plate holdersI - Cutle

Page 5 - • Press the START button

GB -5-Rectifying minor faults yourself ...Switch off the appliance Everything o.k. ...Wash cycleSelect programmeQuick, permanent or alternating109678O

Page 6 - What to do if

GB -6-What to do if...If a fault occurs, before restoring normal appliance operation.contacting the After-sales Service, make the following checks to

Page 7

GB -7-What to do if...Crockery and cutlery... Possible causes... Solutions...salt indicator lit- Use tablets for soft water. - Set “Detergent type”

Page 8

GB -8-What to do if...Disconnect the mains plugIf, after carrying out the above checks, the fault persists, switch off the appliance, disconnect the m