Whirlpool ADP 5778 Instruction for Use download pdf

-1-

Chart

START

DELAY

option

ON/OFF

BUTTON

PROGRAMME

SELECTOR

KNOB

(See Table of

programmes

below)

START BUTTON

The indicator lights up during operation, flashes when a fault occurs, and goes off

at the end of the programme.

START BUTTON RESET FUNCTION:

Press this button for at least 2 seconds; the selected programme and options will

be cancelled. Main failure displays (repeated flashing of the START indicator lamp)

can be cancelled by RESETTING. Detailed instructions are given in chapter

“What to do if...”.

(see at right for options description)

1) Programme data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additional options) and may vary

depending on conditions. Differences of up to 20 minutes are possible with sensor programmes as a result of the appliance’s automatic calibration system

2) Reference programme for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the

EN/Standard loading comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”.

Table of programmes

Detergent

Consumption

Programmes

Available

options

Loading instructions Litres kWh

Minutes

Pre-Wash cold

Delay Crockery to be washed later. — 4.0 0.03 14

Quickwash 40°C

Delay

Lightly soiled crockery, with no

dried-on food.

* Use of tablets

not recommended.

10.0 0.65 30

Eco

50°C

Delay Normally soiled crockery. X 12.0 1.05 150

Daily 60°C

Delay

Normally or heavily soiled

crockery.

X 13.0 1.25 120

Intensive 70°C

Delay

Recommended programme for

heavily soiled crockery, especially

suitable for pots and pans.

X 14.0 1.55 155

DELAYED START

BUTTON

Press the button

(repeatedly) to delay the

start of the programme.

Adjustable from 1 to 24

hours. With each press of

the button, the delayed

start indicator increases by

one hour and after 24

restarts from 00. Then

press the START button.

The dishwasher will start

after the set time.

5019 396 01729ADP 5778

RINSE AID INDICATOR

When lit, the rinse aid dispenser

needs to be refilled.

SALT INDICATOR

When lit, the salt reservoir

needs to be refilled.

FAULT INDICATION AND WASH TIME DISPLAY

In normal operation it indicates the remaining time

(h:mm), whereas with “Delayed start” selected it

indicates the time remaining until programme start (hh).

If “F..” appears on the display, see chapter “What to do

if...”.

Options and display description

BEFORE USING THE APPLIANCE FOR THE

FIRST TIME CAREFULLY READ THIS QUICK

REFERENCE GUIDE AND THE INSTALLATION

INSTRUCTIONS! THE GUARANTEE IS NOT

APPLICABLE IF FAULTS ARE CAUSED BY

INCORRECT USE OF THE APPLIANCE.

Quick reference guide

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - 5019 396 01729ADP 5778

GB -1-ChartSTARTDELAYoptionON/OFFBUTTONPROGRAMMESELECTORKNOB(See Table of programmes below)START BUTTONThe indicator lights up during operation, flash

Page 2 - First time use

GB -2-First time use578623SEL141091- salt reservoir2- rinse aid dispenser3- detergent dispenser4- racks system5,6,7,8- available functions on the pane

Page 3 - Daily use

GB -3-Daily check123Adding rinse aid (not necessary when you use tablets). How to adjust the rinse aid dosage regulatorDaily useThe salt level indicat

Page 4 - How to load the racks

GB -4-How to load the racksHJ(depending on the model)G - Foldable plate holders: They can be folded down to load potsorH- Fixed plate holdersI - Cutle

Page 5 - • Press the START button

GB -5-Rectifying minor faults yourself ...Switch off the appliance Everything o.k. ...Wash cycleSelect programmeQuick, permanent or alternating109678O

Page 6 - What to do if

GB -6-What to do if...If a fault occurs, before restoring normal appliance operation.contacting the After-sales Service, make the following checks to

Page 7

GB -7-What to do if...Crockery and cutlery... Possible causes... Solutions...salt indicator lit- Use tablets for soft water. - Set “Detergent type”

Page 8

GB -8-What to do if...Disconnect the mains plugIf, after carrying out the above checks, the fault persists, switch off the appliance, disconnect the m