Whirlpool ADPF 851 WH Instruction for Use download pdf (Page 20)

How to Drain Excess Water From Hoses

If the sink is 1000 higher from the floor, the excess water in hoses cannot be drained directly into the sink.

It will be necessary to drain excess water from hoses into a bowl or suitable container that is held outside

and lower than the sink.

Water Outlet

Connect the water drain hose. The drain hose must be correctly fitted to avoid water leaks.

Ensure that the water drain hose is not kinked or squashed.

Extension Hose

If you need a drain hose extension, make sure to use a similar drain hose.

It must be no longer than 4 metres; otherwise the cleaning effect of the dishwasher could be reduced.

Syphon Connection

The waste connection must be at a height less than 1000 mm (maximum) from the bottom of the dish.

The water drain hose should be fixed .

Start of Dishwasher

The following things should be checked before starting the dishwasher.

1 The dishwasher is level and fixed properly

2 The inlet valve is open

3 There is a leakage at the connections of the conducts

4 The wires are tightly connected

5 The power is switched on

6 The inlet and drain hoses are knotted

7 All packing materials and printings should be taken out from the dishwasher

Attention: After installation, please make sure to keep this manual. The content of this manual is very

helpful to the users.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27

No comments

Whirlpool ADPF 851 WH Instruction for Use Page 20