Whirlpool DSR 57M94 A S EU Instruction for Use download pdf (Page 31)

Detergent and

dishwasher use

Measuring out the detergent

Good washing results also depend on the correct amount of

detergent being used. Exceeding the stated amount does not

result in a more effective wash and increases environmental

pollution.

The amount can be adjusted to the soil level.

In the case of normally soiled items, use approximately either

25g (powder detergent) or 25ml (liquid detergent). If tablets

are used, one tablet will be enough.

If the crockery is only lightly soiled or if it has been rinsed

with water before being placed in the dishwasher, reduce

the amount of detergent used accordingly.

For good washing results also follow the instructions shown

on the detergent box.

For further questions please ask the detergent producers.

Open the detergent dispenser using button D and measure out

the detergent according to the Table of wash cycles:

• powder or liquid:

compartments A (wash

detergent) and B (pre-wash

detergent)

• tablets: when the cycle

requires 1 tablet, place it in

compartment A and close

cover C; when it requires 2

tablets, place the second tablet

on the bottom of the appliance.

Removedetergentresiduesfromtheedgesofthecompartment

and close cover C until it clicks.

The detergent dispenser automatically opens up at the right time

according to the wash cycle.

Ifall-in-onedetergentsareused,werecommendusingtheTABS

option, because it adjusts the cycle so that the best washing and

drying results are always achieved.

Only use detergent which has been specifically designed

for dishwashers.

DO NOT USE washing up liquid.

Using excessive detergent may result in foam residues

remaining in the machine after the cycle has ended.

To achieve the best washing and drying results, the combined

use of detergent, rinse aid liquid and refined salt is required.

We recommend using detergents that do not contain

phosphates or chlorine, as these products are harmful

to the environment.

Starting the dishwasher

1. Turn the water tap on.

2.PresstheON/OFFbutton.

3.Openthedoorandpourinasuitableamountofdetergent

(seeMeasuringoutthedetergent.)

4.Loadtheracks

(seeLoadingtheracks)

and close the door.

5.Select the wash cycle in accordance with the type of

crockery and its soil level

(seeTable of wash cycles)

pressing the P button.

6.Selectthewashoptions*

(seeOptions).

7.PresstheStart/Pausebuttontostartthecycle(fixedlight):

a long beep signals the start of the wash cycle, the cycle

indicator lights up and the display shows the cycle number

and the time remaining until the end of the cycle.

8.Two short beeps and one long beep indicate the end of the

washcycle,theStart/PausebuttonswitchesoffandthewordEND

appears on the display.

Switchofftheappliancebypressing

theON/OFFbutton.

9. Wait for a few minutes before removing the crockery - to

avoid burns. Unload the racks, beginning with the lower level.

The machine will switch off automatically during long

periods of inactivity in order to minimise electricity

consumption.

AUTO WASH CYCLES*: some models of dishwasher are

equipped with a special sensor which can be used to assess

the level of soiling and automatically select the most efficient and

economic wash cycle accordingly. The duration of the auto wash

cycles may vary due to the operation of the sensor.

Changing a wash cycle in progress

If a mistake was made in the wash-cycle selection process, it is

possible to change the cycle provided that it has only just begun:

Once the wash cycle has started, in order to change the wash

cycleswitchoffthemachinebypressingandholdingtheON/

OFF/Resetbutton.Switchitbackonusingthesamebuttonand

select the desired wash cycle and options.

Adding extra crockery

PresstheStart/Pausebuttonandopenthedoor,takingcareto

avoid the escaping steam. Then place the crockery inside the

dishwasher.PresstheStart/Pausebutton:Thecyclewillstart

again after a long beep has been emitted.

If the delayed start has been set, at the end of the countdown

the wash cycle will not start. It will stay in Pause mode.

PresstheStart/Pausebuttontopausethemachine;thewash

cycle is stopped.

At this stage the wash cycle cannot be changed.

Accidental interruptions

If the door is opened during the wash cycle or there is a power

cut, the cycle stops. It starts again from the point at which it

was interrupted once the door has been shut or the electricity

supply restored.

* Only available in selected models.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 79 80

Comments to this Manuals

No comments

Whirlpool DSR 57M94 A S EU Instruction for Use Page 31

Comments to this Manuals

Related products and manuals for Dishwashers Whirlpool DSR 57M94 A S EU