COMPACTORSUse & Care GuideFor questions about features, operation/performance,parts, accessories or service, call: 1-800-253-1301.In Canada, call
10COMPACTOR USEHow Your Compactor WorksThe compacting ram is the part of the compactor which compresses the trash. The compacting ram does not go to t
11Style 2To start and stop the compactor1. To start the compactor: Turn the Key-Switch to ON. Press ON. Press START. The compactor will automatical
12COMPACTOR CAREYour new compactor is designed to give you many years of dependable service. However, there are a few things you are expected to do in
135. Wash the inside of the cabinet with a clean sponge or soft cloth and a mild detergent in warm water. Rinse and dry thoroughly with a soft cloth.6
14ASSISTANCE OR SERVICEBefore calling for assistance or service, please check “Troubleshooting.” It may save you the cost of a service call. If you st
WHIRLPOOL®COMPACTOR WARRANTYONE-YEAR FULL WARRANTY ON COMPACTORFor one year from the date of purchase, when this compactor is operated and maintained
2TABLE OF CONTENTSCOMPACTOR SAFETY...3INSTALLATION INSTRUCTIONS...
3COMPACTOR SAFETYYou can be killed or seriously injured if you don'timmediately follow instructions.You can be killed or seriously injured if you
4INSTALLATION INSTRUCTIONSInstaller: Leave Use and Care Guide with the homeowner.Homeowner: Keep Use & Care Guide for future reference and for loc
5Cutout dimensionsClearance dimensionsElectrical RequirementsRecommended Grounding MethodThis compactor is for use on a single phase, 115-volt, 60 Hz,
6Freestanding and Undercounter InstallationNOTE: Proper installation is your responsibility. Make sure you have everything necessary for correct insta
7 If the compactor is to be midway between “1” and “3,” place the retaining bracket mounting screws through “2.”7. Slowly lift the front slightly and
8Raised Panel: The outer section of panel must be ⁷⁄₃₂" (5.6 mm) thick to fit into the trim. Use the dimensions shown when designing raised panel
9Trimless Panel without HandleDimensionsUse these dimension drawings to create a custom panel for use without a trim kit. The panel should be ¹⁄₂"
Comments to this Manuals