Whirlpool GSF ECO 9R PC Instruction for Use

Browse online or download Instruction for Use for Dishwashers Whirlpool GSF ECO 9R PC. Whirlpool GSF ECO 9R PC Instruction for Use User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 8
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
GB
-1-
Chart
ON/OFF
BUTTON
PROGRAMME
SELECTION BUTTON
Press button “Program”
(repeatedly) until the required
indicator of programme lights
up (see “Table of
programmes” below).
START BUTTON
The indicator lights up
during operation, and
goes off at the end of the
programme.
RESET BUTTON
For programme change or indication of faults.
Press and hold for 3 sec. this button to cancel a started
programme and selected extra options. Press this button to
cancel the main fault indicators “F..” also refer to the chapter
“What to do if...”. The programme can then be selected and
started.
(see at right for options
description)
1) Programme data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additional options) and may vary
depending on conditions. Differences of up to 20 minutes are possible with sensor programmes as a result of the appliance’s automatic calibration system.
2) Reference programme for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the
EN/Standard loading comparison test and other tests, contact the following address: “[email protected]”.
3) The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on the NF EN 13697 standard of November 2001.
Table of programmes
Detergent
Consumption
P
Programmes
Available
options
Loading instructions Litres Kwh
Minutes
1)
1
Auto 40-70°C
Delay
Multizone
Power Clean
Normally or heavily soiled crockery, including
pots and pans. None soaking or hand pre-
treatment is needed. In addition hygiene of the
complete loading is ensured with this
programme.
X 7-17 0.99-1.75 65-220
2
Pre-Wash cold
Delay
Multizone
Crockery to be washed later. 4.0 0.03 14
3
Glasses 40°C
Delay
Multizone
Light soiling, for example glasses and cups. X 10.0 0.85 100
4
Quickwash 40°C
Delay
Multizone
Lightly soiled crockery, with no dried-on food.
* Not recommended tablets use.
X
*
10.0 0.65 30
5
Eco
2)
50°C
Delay
Multizone
Power Clean
Normally soiled crockery. X 11.0 1.05 150
6
Antibacterial
3)
Delay
Multizone
Power Clean
Normally or heavily soiled crockery, with
additional antibacterial wash. Programme
interruption (e.g. due to door opening) can
compromise elimination of germs.
X 13.0 1.50 115
7
Overnight 55°C
Delay
Multizone
Normally soiled crockery, gentle and quiet
thanks to the lower spray pressure (39dbA).
X 13.0 1.20 290
Options and display description
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS
QUICK REFERENCE GUIDE AND THE INSTALLATION INSTRUCTIONS!
FAULT INDICATION AND WASH TIME DISPLAY
In normal operation it indicates the remaining time (h:mm), whereas with “Delayed start” selected it
indicates the time remaining until programme start (hh) an
d below 1h (0:mm).
If “F..” appears on the display, see chapter “What to do if...”.
KEYBOARD LOCK
This option allows you to lock the buttons on the
control panel. Children will not be able to
accidentally start the dishwasher by pressing the
buttons on the control panel when this option is
selected. If you want to activate or deactivate this
option hold down the
Multi Zone
button for three
(3) seconds. “Keyboard lock indicator” will flash
during activation and acoustic signal will confirm
activation. Deactivation is done in the same way.
MULTIZONE
Allows you to choose
the washing zones.
Press this button
(repeatedly) to select
the wash zones:
both racks
only lower
rack
only upper
rack
POWER CLEAN
Thanks to the
additional power jets
this option provides
a more intensive and
powerful wash in the
lower rack, in the
specific area.This
option is
recommended for
washing pots and
casseroles
(see
page 4)
. Press this
button to activate
Power Clean (the
indicator lights up).
RINSE AID
INDICATOR
When lit, the rinse
aid dispenser
needs to be
refilled.
SALT
INDICATOR
When lit, the salt
reservoir needs to
be refilled.
DELAY
INDICATOR
When lit, the time
selection and
delay start
countdown.
DELAYED START
BUTTON
Press the button
(repeatedly) to delay the
start of the programme.
Adjustable from 1 to 24
hours. With each press of
the button, the delayed start
indicator increases by one
hour and after 24 resets
from 0. Then press the
START button. The
dishwasher will start after
the set time.
KEYBOARD
LOCK
INDICATOR
When lit, the
keyboard lock
option is
activated.
SET THE
DETERGENT
Press to select
tablets. If not
selected then
powder is a
default detergent.
5019 496 01599GSF Eco 9R PC
Quick reference guide
Page view 0
1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - 5019 496 01599GSF Eco 9R PC

GB -1-ChartON/OFF BUTTONPROGRAMME SELECTION BUTTONPress button “Program” (repeatedly) until the required indicator of programme lights up (see “Table

Page 2 - Daily check

GB -2-First time use1- salt reservoir2- rinse aid dispenser3- detergent dispenser4- racks system5,6,7,8- available functions on the panel9- filters10-

Page 3 - Daily use

GB -3-Daily check23Rinse aid indicator (depending on model)The indicator lamp on the control panel lights up when RINSE AID NEEDS TO BE ADDED.dark: OK

Page 4

GB -4-A - Two trays forcutlery(In some models only)B - Adjustable glass holderHow to adjust upper rack height (if available) - It could be useful to l

Page 5 - Maintenance and care

GB -5-109678Overview of programmesThe max. possible number of programmes is illustrated in this overview. The corresponding programmes for your applia

Page 6 - What to do if

GB -6-What to do if...If a fault occurs, before restoring normal appliance operation.contacting the After-sales Service, make the following checks to

Page 7

GB -7-What to do if...Crockery and cutlery...Possible causes...Solutions...salt indicator lit- Use tablets for soft water. - Set “Detergent type” o

Page 8

GB -8-What to do if...If, after carrying out the above checks, the fault persists, switch off the appliance, disconnect the mains plug and turn off th

Comments to this Manuals

No comments