Whirlpool GSI 61202 Di A+ IN Instruction for Use download pdf

GB -1-

Bauknecht is a registered trademark

Chart

START/RESUME BUTTON

Push this button to start the selected program: the

indicator lights up and goes off at the end of the program.

When the door is opened during a washing cycle,

the cycle is temporarily paused: the Start indicator

blinks. To resume the cycle close the door and

push Start button again.

CANCEL/OFF BUTTON

Push this button to switch off the control panel.

If pressed when a program is running it cancels the

program ongoing draining water for 1 minute

(0:01 is shown into the display).

If pressed when the dishwasher is switched off,

it drains any possible liquids from dishwasher

(1 minute process).

PROGRAM SELECTION

BUTTON

Push “P” button (repeatedly)

until selected program number

is shown on the display

(P1...PX) - see “Table of

programs” below.

(see at right for options description)

1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additional options) and may

vary depending on conditions. Differences of up to 20 minutes are possible with sensor programs as a result of the appliance’s automatic

calibration system.

2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the EN/

Standard loading comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”.

Table of programs

Deter-

gent

Consumption

Drying

Phase

Programs

Available

options

Loading instructions

Litres kWh

Minutes

)

Sensor 40°-70°C

Delay

Half load

Recommended program for

routine washes, with dried-on

food (e.g. EN 50242).

X 7-14 1.00-1.60 70-155 Full

Pre-wash cold

Delay

Crockery to be washed later.

— 4.0 0.03 14 NO

Express 45°C.

Delay

Lightly soiled crockery, with no

dried-on food.

X 11.0 0.80 30 NO

Eco

50°C.

Delay

Half load

Normally soiled crockery.

Energy-saving program.

X 11.5 1.03 170 Full

Normal 60°C.

Delay

Half load

Normally soiled crockery.

X 10.0 1.30 80 Full

Steam

Delay

Program including steam action

dedicated for heavily soiled

crockery, pots and pans. Soaking

or hand pretreatment is no

longer needed.

X 14.0 1.70 180 Full

5019 496 01800

Options and display description

SALT INDICATOR

When lit (at the end of the cycle),

the salt reservoir needs to be

refilled.

TABLET SETTING

This setting allows to optimize

the cycle performances

according the type of detergent

used.

Push the Tablet button for

3 seconds (until the indicator

lights up) if you are using the

combined detergents in tablet

(rinse aid, salt and detergent in

1dose).

If you are using powder

detergent or liquid detergent, the

Tablet indicator on the control

panel has to be off.

RINSE AID INDICATOR

When lit (at the end of the cycle),

the rinse aid dispenser needs to

be refilled.

WASH TIME DISPLAY

Indicated the cycle duration and the remaining time (h:min). With “Delayed start” selected it indicates

the time remaining until program start (h.00) - below 1h (0:min).

If “Fx Ey” messages appears on the display, see page 6 - chapter “What to do if...”.

BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS

QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!

THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY

BUTTON EXCEPT CANCEL/OFF BUTTON.

FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES

AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.

HALF LOAD BUTTON

Half load cycle can be used for the upper or lower rack. Select the

required program then press the “Half Load” button - the light

comes on. Turns off at the end of the program.

The “Half Load” option can be used with the programs indicated

in the table of programs.

DELAYED START BUTTON

Push the button (repeatedly)

to delay the start of the

program - delay indicator turns

on. Adjustable from 1 to

24 hours.

With each press of the button,

the delay increases by one

hour and after “h 24” returns

to “h 00”. When this option is

selected the delay indicator

turns on. Then press the

START button. The

dishwasher will start after the

set time.

Quick reference guide

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - 5019 496 01800

GB -1-Bauknecht is a registered trademarkChartSTART/RESUME BUTTONPush this button to start the selected program: the indicator lights up and goes off

Page 2 - Daily check

GB -2-First time use14109235 7861- salt reservoir2- rinse aid dispenser3- detergent dispenser4- racks system5,6,7,8- available functions on the pan

Page 3 - Daily use

GB -3-Daily check3Check the rinse aid indicator to check the level into the dispenser.(depending on the model)Rinse aid indicator on the control panel

Page 4 - How to load UPPER RACK

GB -4-Switching on the appliance. Press any button (except CANCEL/Off button) to switch on the control panel and start programming.How to load UPPER R

Page 5 - Maintenance and care

GB -5-Switching off the appliance. Everything OK...Wash cycleSelect program678Maintenance and careMaintenance and careOverview of programsThe max. pos

Page 6 - What to do if

GB -6-What to do if...If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem.Most fault

Page 7

GB -7-What to do if...Crockery and cutlery... Possible causes... Solutions...salt indicator lit - Use tablets for soft water. - Set “Tablet” option

Page 8

GB -8-What to do if...If, after carrying out the above checks, the fault persists, disconnect the mains plug and turn off the water tap. Contact the A