Whirlpool GSIP 6517/2 IN Instruction for Use download pdf

Before using the dishwasher, read the

installation and maintenance instructions carefully!

5019 496 01110

GSIP 6517

1) Program data obtained in conformity with European standard EN 50242. Values may vary in relation to usage, e.g. different loads,

options, different sensor settings (only with sensor programmes), different water supply temperatures, as well as water hardness

and power supply voltage.

2) Energy label programme in compliance with EN 50242. - Information for Test Laboratories:

for more detailed information on

the EN comparison test and other tests, contact the following address: “[email protected]”.

3) The antibacterial action has been shown in collaboration with the Pasteur Institute, Lille (France), in conformity with.

Standard NF EN 13697 - November 2001.

1. OVERVIEW

Programme selector

START button

Switches “on” when the dishwasher is operating. Flashes when a

fault occurs. Switches off at the end of the programme.

START button RESET function:

Press this button for at least 2 seconds; the selected programme

and options are cancelled. Main failure displays (repeated flashing

of the START indicator lamp) can be cancelled by RESETTING.

Detailed instructions are given in chapter 5 “What to do if...”.

Salt level indicator and rinse aid level indicator

They light up when salt or rinse aid need to be added.

Add just before starting a wash cycle.

Fault indication and wash time display

With normal operation, the display indicates residual time (h:mm),

while with the “Delayed start” function selected it indicates time

remaining until the start of the programme (hh).

If “F..” appears on the display, see chapter 5 “What to do if...”.

Detergent setting upon initial use and when using a different type of detergent

1. Select the third programme in the relative table.

2. Press the START button for approx. 7 sec. to change the display.

3. Using the START button, select the desired detergent:

Display shows: 2 -1 = 2 in 1, 3 -1 = 3 in 1, 4 -1 = other combined action

detergents (in this way, the rinse aid and/or salt indicator is deactivated).

Display shows OFF = Powder detergent (factory setting).

(rinse aid level and salt level indicator activated).

4. Switch the appliance off and then switch it on again. The selected detergent

type will be indicated on the display for approx. 3 seconds.

“Delayed start” button

Press the button as required to delay the start of the programme.

Adjustable from 1 to 24 hours. With each press of the button, the

delayed start indicator increases by one hour and after 24 restarts

from 00. Then press the START button. The dishwasher will start

after the set time.

Half Load / Multizone Button”

The half load cycle can be used for the upper or lower rack. Select

the required programme then press the “Half load” button. The

light comes on and goes off at the end of the programme.

This function can be used with the programmes indicated in table 1.1.

Antibacterial rinse

This function activates an antibacterial rinse at the end of the wash

cycle, guaranteeing a further reduction of bacteria. Press the button to

activate or deactivate the function. This function can be used with

those programmes marked with the relative symbol in table 1.1.

The dishwasher door must be kept shut for the entire duration of

the programme in order to guarantee reduction of bacteria. If the

door is opened the indicator lamp starts flashing.

On / Off Button

Table 1.1.

Table of programmes

Detergent

dispenser

Consumption

Programmes

Available

options

Loading instructions

large small Litres kWh Minutes

Pre-Rinse cold

— Crockery to be washed later. — — 4.0 0.03 14 ±

Quickwash 40°C

—

Lightly soiled crockery, without dry

residuals.

X — 10.0 0.65 30 ±

Bio

50°C

Normally soiled crockery. Energy-saving

programme.

X X 12.0 1.05 165 ±

Daily 60°C

Normally or heavily soiled crockery. X X 13.0 1.25 120 ±

Intensive 70°C

Recommended programme for heavily

soiled crockery, especially suitable for

pans and saucepans.

X X 14.0 1.55 155 ±

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - 1. OVERVIEW

1GBBefore using the dishwasher, read the installation and maintenance instructions carefully!5019 496 01110GSIP 65171) Program data obtained in confor

Page 2 - 2. QUICK REFERENCE GUIDE

22. QUICK REFERENCE GUIDEDetailed instructions are given on the following pages; also see section “5. What to do, in case of...”1. Switch on the appli

Page 3 - 3. HOW TO USE THE APPLIANCE

33. HOW TO USE THE APPLIANCEPROGRAMME SELECTIONPress the button “Select programme” or the programme selector to display the selected programme. The ap

Page 4

43. HOW TO USE THE APPLIANCEc. How to adjust the rinse aid dosage regulatorThe rinse aid dosage can be adjusted to the detergent used. The lower the s

Page 5

53. HOW TO USE THE APPLIANCEHOW TO LOAD THE RACKSUPPER RACK - depending on the modelLong-handled utensils (kitchen knives) must be arranged with the s

Page 6

64. PRECAUTIONS AND GENERAL RECOMMENDATIONS1. PackingThe packaging materials are 100% recyclable and marked with the recycling symbol. .2. Removing t

Page 7 - 5. WHAT TO DO IF

75. WHAT TO DO IF...If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem. Most faults

Page 8

85. WHAT TO DO IF...Crockery and cutlery ... Possible causes/solutions...are not perfectly clean/have food residues- In the event of frequent use of l