Whirlpool W10869845 Installation Manual download pdf (Page 6)

6. Stand dryer up and slide to front

of washer

Lift the dryer back to an upright position, keeping it on

the cardboard (or carton bottom). Use the cardboard to slide

the dryer to the front of the washer to avoid damaging the

rubber feet.

7. Place dryer on washer

Lift the dryer up and set securely on top of washer. Position

dryer to slightly overhang the back of the washer – too much

overhang will allow the rear feet to slip off the back of the

washer top.

8. Install plastic clips

Remove the plastic clips (2), brackets (2), and pan-head

screws (4) from the parts bag. Take a plastic clip (A) and, with

the at side facing out, push it down onto the lower edge of

the slot (B) in the dryer back. A at-blade screwdriver may

help to open the plastic clip slightly. Repeat on other side.

9. Install brackets

Push the hooked end of the bracket (C) down over the plastic

clip (A). A at-blade screwdriver may help to seat the bracket

over the plastic clip. Slide the dryer forward as needed and

attach bracket (C) to washer with pan-head screws (D).

Tighten screws securely. Repeat on other side.

COMPLETE INSTALLATION

Follow the Installation Instructions that came with your

washer and dryer to remove the shipping bolts and complete

the installation.

5. Install feet on dryer

Using a wrench or slip-joint pliers, install the new feet, turning

them fully into the bottom of the dryer.

Feet fully inserted in bottom of dryer

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

No comments

Whirlpool W10869845 Installation Manual Page 6