Whirlpool WGD7600XW Use and Care Guide download pdf (Page 9)

Changing Cycles, Modifiers, and Options

You can change Automatic and Manual Cycles, Modifiers, and

Options anytime before pressing Start.

■ Three short tones sound if an unavailable combination is

selected. The last selection will not be accepted.

Changing Cycles after pressing Start/Pause

1. Press START/PAUSE twice.

2. Select the de

sired cycle and options.

3. Press START/PAUSE. The dryer starts at the beginning of the

new cycle.

NOTE: If yo

u do not press Start within 5 minutes of selecting the

cycle, the dryer automatically shuts off.

Changing Modifiers and Options after pressing

Start/Pause

You can change an Option or Modifier anytime before the selected

Option or Modifier begins.

1. P

ress START/PAUSE once.

2. Select the n

ew Option and/or Modifiers.

3. Press START/PAUSE to continue the cycle.

NOTE: If you happen to press START/PAUSE twice, the program

clears and your dryer shuts down. Restart the selection process.

Changing the Preset Dryness Level Settings

If all of your loads on all Automatic cycles are consistently not as

dry as you would like, you may change the preset Dryness Level

settings to increase the dryness. This change will affect all of your

Automatic cycles.

Your Dryness Level settings can be adjusted to adapt to different

installations, envir

onmental conditions or personal preference.

There are 3 drying settings: 1 (factory preset dryness level),

2 (slightly dryer clothes, approximately 15% mor

e drying time),

and 3 (much dryer clothes, approximately

30% more drying time).

1. The Dryness Level settings cannot be changed while the dryer

is running.

2. Pr

ess and hold the DRYNESS LEVEL button for 5 seconds.

The dryer will beep, and “CF” will be displayed for 1 second

followed by the current drying setting.

3. T

o select a new drying setting, press the DRYNESS

LEVELbutton again until the desired drying setting is shown.

NOTE: Wh

ile cycling through the settings, the current setting

will not flash, but the other settings will flash.

4. Pr

ess START/PAUSE to save the drying setting.

5. The dry

ing setting you selected will become your new preset

drying setting for all Automatic cycles.

Drying Rack Option

Use the Drying Rack to dry items such as sweaters and

pillows without tumbling. The drum tur

ns, but the drying rack

does not move.

If your model does not have a drying rack, you may be able to

pur

chase one for your model. To find out whether your model

allows drying rack usage and for information on ordering, please

refer to the front page of the manual or contact the dealer from

whom you purchased your dryer.

NOTE: The drying

rack must be removed for normal tumbling.

Do not use the automatic cycle with the drying rack.

To use the drying ra

1. Open dryer door.

A. Front edge

2. Place drying rack inside dryer drum, positioning the back wire

on the ledge of the inner dryer back panel. Push down on front

edge of drying rack to secure at the front of the dryer.

A. Drying rack front edge

B. Dryer back panel

3. Put the wet items on top of the drying rack. Leave space

between the items so air can reach all the surfaces.

NOTE: Do n

ot allow items to hang over the edge of the

drying rack.

4. Cl

ose the door.

5. Pr

ess the POWER button.

6. Select Man

ual Cycle and select a temperature (see following

chart). Items containing foam, rubber or plastic must be dried

on a clothesline or by using the Air Only temperature setting.

7. Y

ou must select a time by pressing TIME ADJUST Up or

Down. Reset time as needed to complete drying. Refer to the

following table.

8. Press (and hold) START/PAUSE button (about 1 second).

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Comments to this Manuals

No comments

Whirlpool WGD7600XW Use and Care Guide Page 9

Comments to this Manuals

Related products and manuals for Electric laundry dryers Whirlpool WGD7600XW