Whirlpool WGD7600XW User Manual download pdf (Page 14)

LEvEL DRYER

Level Dryer

Not Level LEVEL Not Level

Check levelness of dryer from side to side. Repeat from

front to back.

NOTE: The dryer must be level for the moisture sensing

system to operate correctly.

Place

level here

Place

level here

If dryer is not level, prop up using a wood block, use wrench

to adjust legs up or down, and check again for levelness. Once

legs are level, make sure all four legs are snug against the oor.

Adjust leveling legs

CONNECT vENT

1. Connect vent to exhaust outlet

Using a 4" (102 mm) clamp, connect vent to exhaust outlet

in dryer. If connecting to existing vent, make sure vent is

clean. Dryer vent must t over dryer exhaust outlet and inside

exhaust hood. Check that vent is secured to exhaust hood

with a 4" (102 mm) clamp.

Move dryer to nal location

Move dryer to nal location. Avoid crushing or kinking vent.

After dryer is in place, remove cardboard from under dryer.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 35 36

No comments

Whirlpool WGD7600XW User Manual Page 14