15.5" PEDESTAL INSTALLATION INSTRUCTIONS For use only with front load washers and dryers INSTRUCTIONS D’INSTALLATION DU PIÉDESTAL DE 15,5" P
10Pièces fournies :Quatre vis de tôlerie n° Cloison du tiroir 12 x 3/4" à tête hexagonale1. Vider le tiroir du piédestalDESEMBALLAGE DU PIÉDES
11REMARQUE : Si la laveuse doit être transportée, appeler le centre de service local. An d’éviter tout endommagement de la suspension et de la stru
12Installation d’une laveuse/sécheuse nouveau1. Déballer la laveuse/sécheuse et les placer à proximité de l’emplacement d’installation prévu.2. Prépa
133. Fixation du piédestal à la laveusePlacer le piédestal contre le fond de la laveuse. L’avant de la caisse du piédestal doit être aligné avec la
141"(25 mm)2. Préparer les pieds du piédestalÀ l’aide d’un cliquet à tête hexagonale de 1/4" ou d’une clé plate, abaisser les pieds jusqu’à
15Nivellement de la laveuse/sécheuse1. Déplacer l’appareil près de son emplacement dénitifSuivre les Instructions d’installation fournies avec v
2. Placer la cloison du tiroir dans le tiroirRetirer la pellicule d’expédition du tiroir. Placer la cloison dans le tiroir à l’emplacement souha
2TOOLS AND PARTSGather the required tools and parts before starting installation.Tools Needed:Utility knife 1/4" hex-head ratchet or
3NOTE: If the washer is to be transported, call your local service center. To avoid suspension and structural damage, your washer must be properly se
4Installation of new washer/dryer1. Unpack the washer/dryer and move close to the intended installation location.1. Unplug the power supply cord or
52. Prepare the washerWasher bottomPartially install two of the #12 x 3/4" hex-head sheet metal screws in the indicated holes. Leave a space of
64. Secure pedestal to dryer Position the pedestal toward the front of the dryer and install the two remaining hex-head sheet metal screws. Do not t
71"(25 mm)2. Prepare pedestal feet Using a 1/4" hex head ratchet or open-end wrench, lower the feet approximately 1" (25 mm) away from
83. Adjust pedestal feet4. Securely tighten jam nuts 2. Place drawer divider in drawerHex-head screwDrawer slide1. Reassemble pedestal drawer 2. Check
9SÉCURITÉ DU PIÉDESTALNiveau Clé plate 9/16" Pince ou pince articulée Seau EXIGENCES D’INSTALLATIONEXIGENCES D’EMPLACEMENTREMA
Comments to this Manuals