Whirlpool 2205958 Use and Care Guide download pdf (Page 12)

The dispenser light

The dispenser area has a light. It can be turned on manually by

pressing the ON button at the right hand side of the control panel.

The red indicator above the ON button will appear.

On some

models:

Whenever you use the dispenser the lever will

automatically turn the light on.

NOTE:

See the “Changing the Light Bulbs” section for

information on changing the dispenser light bulb.

On models without crushed ice, the light switch is a rocker-style

type. Push the switch to turn the light on, and push again to turn

the light off.

The dispenser lock

(on some models)

Your dispenser can be turned off for easy cleaning or to prevent

accidental dispensing by small children and pets. To turn off the

dispenser, press the LOCK button. The indicator will appear

above the LOCK button and the ice and water dispensers will not

work. To unlock the dispenser, press the UNLOCK button until

the indicator appears. Then continue to dispense ice or water as

usual.

NOTE:

The lock feature does not shut off power to the product,

to the ice maker, or to the dispenser light. It simply deactivates

the dispenser levers.

Base Grille Water Filtration and Monitoring

System

(on some models)

The base grille water filter status light

The water filter status light will help you know when to change

your water filter cartridge. The light is located at the top of the

refrigerator compartment. The light will change from

green

yellow

. This tells you that it is almost time to change the water

filter cartridge (90% of the filter life has been used). It is

recommended that you replace the base grille water filter

cartridge when the water filter indicator light changes to

red

water flow to your water dispenser or ice maker decreases

noticeably. (See “Changing a base grille water filter cartridge”

later in this section.)

NOTE: Do not use with water that is microbiologically unsafe

or of unknown quality without adequate disinfection before

or after the system.

1. Status Light

2. Light Switch

After changing the water filter cartridge, reset the water filter

status light by pressing the

light switch

5 times within 10

seconds. The status light will change from red to green when the

system is reset.

Non-indicator water filter (on some models)

If your refrigerator does not have the water filter status light, you

should change the water filter cartridge every 6-9 months

depending upon your usage. If the water flow to the water

dispenser or icemaker decreases noticeably before 6 months

have passed, replace the water filter cartridge more often. (See

“Changing a base water filter cartridge” later in this section.)

Changing a base grille water filter cartridge

The base grille water filter is located below the freezer

compartment door.

Locate the water filter cartridge cap in the front base grille

below the freezer compartment door. Rotate the cap

counterclockwise to a vertical position and pull the cap and

filter cartridge out through the base grille.

NOTE:

There will be water in the cartridge. Some spilling may

occur.

Remove the cartridge cap by sliding it off the end of the old

cartridge. The cap will slide to the left or right. DO NOT

DISCARD THE CAP.

Take the new cartridge out of its packaging and remove

protective cover from o-rings.

Slide the cartridge cap onto the new cartridge as shown

above in Step 2.

With cartridge cap in the vertical position, push the new filter

cartridge into the base grille until it stops. Rotate the cartridge

cap clockwise to a horizontal position.

LIGHT

OFF ON

DISPENSER

LOCK

UNLOCK

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 55 56

Comments to this Manuals

No comments

Whirlpool 2205958 Use and Care Guide Page 12

Comments to this Manuals

Related products and manuals for Fridges Whirlpool 2205958