Whirlpool ART 886/H Instruction for Use download pdf (Page 11)

INSTALLATION

• Before switching the appliance on, remove the

compressor fixing block

• Do not install the refrigerator close to any heat source.

• Place it in a dry and well ventilated space.

• Make sure that the appliance is well levelled.

Adjust the front feet if required.

• Leave at least a 50 mm gap above the appliance.

• Some models have lateral protruding sides which

allow the direct positioning of the appliance against

the rear wall. Otherwhise fit the spacers (if provided)

at the rear of the appliance, on top of the

condenser.

• Clean the inside (see chapter “How to clean your

appliance”)

• Mount the accessories.

Electrical connection

• Electrical connection must be made in

accordance with local regulations.

• Voltage, power consuption and earthing information

is show on the rating plate (at the side of the

crispers).

• The electrical system must be equipped with an

earth wire, as prescribed by law.

The Manufacturer declines all liability for injery

to persons or damage to property resulting

from the failure to observe these instructions.

• Do not make the electrical connection using

estension leads, adapters, etc.

For Great Britain only:

ELECTRICAL INFORMATION

WARNING - THIS APPLIANCE MUST BE EARTHED

Fuse replacement

If the mains lead of this appliance is fitted with a BS

1363A 13 amp fused plug, to change a fuse in this

type of plug use an A.S.T.A. approved fuse to BS 1362

type and proceed as follows:

1. Remove the fuse cover (A) and fuse (B)

2. Fit replacement 13A fuse into fuse cover

3. Refit both into plug.





1 2 ... 6 7 8 9 10 11 12

No comments

Whirlpool ART 886/H Instruction for Use Page 11